The fall prevention wire rope is designed to support the unit when suspended. Do not apply any load to it other than the
load of the unit.
Mounting space
Refer to the following drawing when determining the mounting location and direction, taking into consideration the
space required for turning the lens and the wiring at the rear of the unit.
A: Camera head range of movement (e.g. SEL70200GM2 (with SEL20TC attached): Ø340)
B: Ceiling bracket (hole on ceiling side (Ø60))
C: Mounting alignment hole
Note
Mount on a ceiling (such as concrete) with sufficient strength.
To mount the unit on a ceiling with insufficient strength, provide sufficient reinforcement.
Mount it in a stable location that is not subject to vibration. Locations subject to vibration may cause vibration in the image.
If the unit must be mounted on an inclined surface, keep it within ±15° of the horizontal and take measures to prevent the
unit from falling.
The side opposite the △ hole on the ceiling bracket is the shooting direction (camera front side).
Slide the pan/tilt lock lever to the UNLOCK position to unlock pan/tilt and turn the camera head by 180° in
the tilt direction.
2
Slide the pan/tilt lock lever to the LOCK position to lock the pan/tilt of the camera head.
3
