637429
27
Zoom out
Zoom in
Previous page
1/36
Next page
Sound Bar
HT-S100F/SF150
Operating Instructions
2
GB
Do not install the appliance in a
confined space, such as a bookcase or
built-in cabinet.
To reduce the risk of fire, do not cover
the ventilation opening of the appliance
with newspapers, tablecloths, curtains,
etc.
Do not expose the appliance to naked
flame sources (for example, lighted
candles).
To reduce the risk of fire or electric
shock, do not expose this appliance to
dripping or splashing, and do not place
objects filled with liquids, such as vases,
on the appliance.
The unit is not disconnected from the
mains as long as it is connected to the
AC outlet, even if the unit itself has been
turned off.
As the main plug is used to disconnect
the unit from the mains, connect the
unit to an easily accessible AC outlet.
Should you notice an abnormality in the
unit, disconnect the main plug from the
AC outlet immediately.
CAUTION
Risk of explosion if the battery is
replaced by an incorrect type.
Do not expose batteries or appliances
with battery-installed to excessive
heat, such as sunshine and fire.
Indoor use only.
Recommended cables
Properly shielded and grounded cables
and connectors must be used for
connection to host computers and/or
peripherals.
For the Bar Speaker
The nameplate is located on the bottom
of the Bar Speaker.
For the customers in Europe
Notice for customers: the
following information is only
applicable to equipment sold in
countries applying EU directives.
This product has been manufactured by
or on behalf of Sony Corporation.
EU Importer: Sony Europe Limited.
Inquiries to the EU Importer or related to
product compliance in Europe should
be sent to the manufacturer’s
authorized representative, Sony
Belgium, bijkantoor van Sony Europe
Limited, Da Vincilaan 7-D1, 1935
Zaventem, Belgium.
Hereby, Sony Corporation declares that
this equipment is in compliance with
Directive 2014/53/EU.
The full text of the EU declaration of
conformity is available at the following
internet address: http://
www.compliance.sony.de/
This equipment has been tested and
found to comply with the limits set out
in the EMC regulation using a
connection cable shorter than 3 meters.
WARNING
3
GB
Disposal of waste
batteries and
electrical and
electronic
equipment
(applicable in the
European Union
and other countries with separate
collection systems)
This symbol on the product, the battery
or on the packaging indicates that the
product and the battery shall not be
treated as household waste. On certain
batteries this symbol might be used in
combination with a chemical symbol.
The chemical symbol for lead (Pb) is
added if the battery contains more than
0.004% lead. By ensuring that these
products and batteries are disposed of
correctly, you will help to prevent
potentially negative consequences for
the environment and human health
which could be caused by inappropriate
waste handling. The recycling of the
materials will help to conserve natural
resources. In case of products that for
safety, performance or data integrity
reasons require a permanent
connection with an incorporated
battery, this battery should be replaced
by qualified service staff only. To ensure
that the battery and the electrical and
electronic equipment will be treated
properly, hand over these products at
end-of-life to the appropriate collection
point for the recycling of electrical and
electronic equipment. For all other
batteries, please view the section on
how to remove the battery from the
product safely. Hand the battery over to
the appropriate collection point for the
recycling of waste batteries. For more
detailed information about recycling of
this product or battery, please contact
your local Civic Office, your household
waste disposal service or the shop
where you purchased the product or
battery.
For the customers in Australia or
New Zealand
It should be installed and operated with
at least 20 cm and more between the
radiator and person’s body (excluding
extremities: hands, wrists, feet and
ankles).
For the customers in Australia
Disposal of old
electrical &
electronic
equipment
(applicable in the
European Union
and other
countries with
separate
collection systems)
4
GB
Table of Contents
About These Operating
Instructions ............................. 4
What’s in the Box .......................... 5
What You Can Do with the
System .................................... 6
Guide to Parts and Controls ..........7
Preparing for Using the
System
Mounting the Bar Speaker on a
Wall ........................................ 13
When the TV Remote Control does
not Work ................................ 15
Listening to the Sound
Listening to a TV and Other
Devices ...................................16
Listening to Music on a USB
Device .................................... 17
Selecting the Sound Effect
Adjusting the Sound ....................19
Listening to Music/Sound
with the BLUETOOTH®
Function
Listening to Music from a Mobile
Device .................................... 21
Turning the System On by
Operating the BLUETOOTH
Device ....................................23
Turning the BLUETOOTH Function
Off ..........................................23
Using the Various Functions
Using the Control for HDMI
Function ................................ 24
Saving Power Consumption ........25
Troubleshooting
Troubleshooting .......................... 26
Resetting the System .................. 30
Additional Information
Specifications ............................... 31
Playable Types of Files
(USB Input) .............................32
Supported Input Audio Formats
(HDMI OUT (TV (ARC)) or TV IN
(OPTICAL)) ..............................32
On BLUETOOTH
Communication .....................33
Precautions ................................. 34
About These Operating
Instructions
The instructions in these Operating
Instructions describe the controls on
the remote control.
Some illustrations are presented as
conceptual drawings, and may be
different from the actual products.
The default settings are underlined on
each feature description.
Basic Setup
Startup Guide
(separate
document)
5
GB
What’s in the Box
•Bar Speaker (1)
• Remote control (1)
R03 (size AAA) battery (2)
• Optical digital cable (1)
AC power cord (mains lead) (1)
– U.K./Ireland models
– Australia/New Zealand models
• WALL MOUNT TEMPLATE (1)
•Startup Guide
• Operating Instructions
6
GB
What You Can Do with the System
“Listening to a TV and Other Devices”
(page 16)
Blu-ray Disc™ player, cable
box, satellite box, etc.
Connecting the TV
(refer to “Startup Guide” (separate
document))
“Using the Control for HDMI Function”
(page 24)
“Listening to Music
on a USB Device”
(page 17)
“Listening to Music from a
Mobile Device” (page 21)
7
GB
Guide to Parts and Controls
Details are omitted from the illustrations.
Front
Remote control sensor
Point the remote control at the
remote control sensor to operate
the system.
 (power) button
Turns on the system or sets it to
standby mode.
(input select) button
(page 16)
BLUETOOTH button (page 21)
+/– (volume) buttons
Indicators
For details, see “About the
indicators on the Bar Speaker”
(page 8).
Bar Speaker
8
GB
About the indicators on the Bar Speaker
Lighting and flashing of the indicator(s) on the Bar Speaker indicate the input or
status of the input device.
The indicators flash when turning on/off the function setting or operating the remote
control.
Indicators Status
Lights: TV input is selected.
Lights in blue: BLUETOOTH connection is established (BLUETOOTH input is
selected).
Flashes quickly in blue: While waiting for connection with a device.
Flashes in blue: While reconnecting or performing pairing.
Lights: USB input is selected.
Flashes twice: The play mode is changed.
Flashes three times first, then flashes slowly repeatedly: When connecting an
unsupported device.
Flashes repeatedly: While reading data of the connected USB device.
Indicators Status
Flashes twice: One of the following functions is set to on.
–Night mode (page19)
–Voice mode (page19)
Flashes once: The audio channel is set to Main (page 20), the sound mode is
selected (page 19), or one of the following functions is set to off.
–Night mode (page19)
–Voice mode (page19)
Flashes twice: One of the following functions is set to on.
Dolby DRC (page 20)
Control for HDMI (page 24)
BLUETOOTH standby (page 23)
–BLUETOOTH function (page23)
Auto standby (page 25)
IR repeater (page 15)
Flashes once: The audio channel is set to Sub (page 20) or one of the following
functions is set to off.
Dolby DRC (page 20)
Control for HDMI (page 24)
BLUETOOTH standby (page 23)
–BLUETOOTH function (page23)
Auto standby (page 25)
IR repeater (page 15)
Flash once: The audio channel is set to Main/Sub (page 20).
Flash quickly: The protection feature is activated (page 29).
• Flash slowly: The system enters standby mode by the auto standby
function (page 25).
9
GB
The indicators flash while adjusting the volume level.
Tip
You can turn the indicators off by pressing INDICATOR.
Even if the indicators are turned off by pressing INDICATOR, if you operate the system, the
indicators in relation to the operation light or flash.
Indicators Status
Flashes once: The volume level is low.
Flash once: The volume level is medium.
Flash once: The volume level is high.
Flash repeatedly: The sound is muted.
Flash twice: The volume level is set to maximum/minimum.
10
GB
Rear
AC IN terminal
HDMI OUT (TV (ARC)) jack
Connect a TV that has an HDMI
input jack with an HDMI cable.
The system is compatible with
Audio Return Channel (ARC). ARC
is the function that sends TV
sound to an AV device such as the
system from the TV’s HDMI jack.
(USB) port (page 17)
TV IN (OPTICAL) jack
IR repeater (page 15)
Transmits the remote signal of
the TV remote control to the TV.
11
GB
Some buttons function differently
depending on how long the button is
pressed. The icons below indicate how
long to press the button.
: Press the button.
: Press and hold the button for 5
seconds.
INPUT (page 16)
Selects the playback source. When
you press INPUT once, the current
input indicator flashes.
Press INPUT again to select the
device you want.
Each time you press INPUT, the
input changes cyclically as follows.
TV input BLUETOOTH input
USB input
AUTO SOUND (page 19)
Selects AUTO SOUND for the sound
effect.
CINEMA
: Selects CINEMA for the sound
effect. (page 19)
: Turns on/off the auto standby
function. (page 25)
VOICE
: Turns on/off the voice mode.
(page 19)
: Turns on/off the Control for
HDMI function. (page 24)
(volume) +*/–
Adjusts the volume.
INDICATOR (page 8)
Turns on/off the indicators on the
Bar Speaker.
PLAY MODE (page 17)
Selects the play mode for USB
playback.
/ (page 17)
Select the content on the TV screen
for USB playback.
Remote Control
27
GB
of the TV and the system from the AC
outlets (mains), then connect them
again.
When the system and TV are
connected with an HDMI cable, check
the following.
– The HDMI jack of the connected TV
is labeled with “ARC.”
The Control for HDMI function of the
TV is set to on.
On the system, the Control for HDMI
function is set to on (page 24).
If your TV is not compatible with
Audio Return Channel, connect the
optical digital cable (supplied) (refer
to the supplied Startup Guide). If the
TV is not compatible with Audio
Return Channel, TV sound will not be
output from the system even if the
system is connected to the TV’s HDMI
IN jack.
If the sound of the device that is
connected to the optical input jack of
the TV is not output, try the following.
– Connect the cable box or satellite
box directly to the TV IN (OPTICAL)
jack of the system.
Press INPUT repeatedly to select the
TV input (page 16).
Increase the volume on the TV or
cancel muting.
Depending on the order in which you
connect the TV and the system, the
system may be muted. If this
happens, turn on the TV first, then the
system.
Set the speakers setting of the TV
(BRAVIA) to Audio System. Refer to
the operating instructions of your TV
regarding how to set the TV.
Check the sound output of the TV.
Refer to the operating instructions of
the TV for the TV settings.
The system supports the Dolby Digital
and PCM audio formats (page 32).
When you playback unsupported
format, set the digital audio out
setting of the TV (BRAVIA) to “PCM.”
For details, refer to the operating
instructions of your TV.
The sound is output from both the
system and the TV.
Mute the sound of the system or the
TV.
No sound or only a very low-level
sound of the device connected to
the system is heard from the
system.
Press + and check the volume
level (page 11).
Press
or + to cancel the muting
function (page 11).
Make sure the input source is
selected correctly. You should try
other input sources by pressing
INPUT repeatedly (page 16).
Check that all the cables and cords of
the system and the connected device
are firmly inserted.
If the connected device supports the
up-sampling feature, you need to
turn it off.
The surround effect cannot be
obtained.
Depending on the input signal and the
sound mode setting, surround sound
processing may not work effectively.
The surround effect may be subtle,
depending on the program or disc.
To play multi channel audio, check
the digital audio output setting on
the device connected to the system.
For details, refer to the operating
instructions supplied with the
connected device.
The USB device is not recognized.
Try the following:
Turn the system off.
Remove and reconnect the USB
device.
Turn the system on.
USB Device Connection
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony HT-SF100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony HT-SF100 in the language / languages: English as an attachment in your email.

The manual is 1,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sony HT-SF100

Sony HT-SF100 User Manual - German, Dutch, Swedish - 204 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info