610365
12
Zoom out
Zoom in
Previous page
1/192
Next page
12
Step 2 Preparing the power supply
Avoiding breaks in operation due to dead batteries
If you use both an internal battery pack and an external battery connected to the DC IN
12V connector at the same time, you can avoid breaks in operation due to the dead
batteries.
When the external battery begins to fail and an internal
battery pack is installed
Remove the DC output cable of the external battery from the DC IN 12V connector. The
power source will switch to the internal battery pack.
When the external battery begins to fail and an internal
battery pack is not installed
First install a fully charged internal battery pack to the camcorder, then remove the DC
output cable of the external battery from the DC IN 12V connector. The power source
will switch to the internal battery pack. To use an external battery again, connect a fully
charged external battery to the DC IN 12V connector before removing the internal
battery pack. The power source will switch to the external battery.
Continuous operation when operating with only an internal
battery pack
First, connect a fully charged external battery to the DC IN 12V connector, then change
the internal battery.
Notes
Whenever an internal battery pack is installed and an external battery is connected to
the DC IN 12V connector, the external battery is always used as the power source.
There may be some noise on the video or audio signal at the instant the power sources
are switched.
When changing the battery pack, make sure that the POWER switch is set to OFF.
When using the two NP-1B battery packs, be sure to change both of them at the same
time.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony DSR-250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony DSR-250 in the language / languages: English as an attachment in your email.

The manual is 2,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info