Help Guide
Digital Still Camera
DSC-RX0M2
Bluetooth Rmt Ctrl
You can operate the camera using a Bluetooth remote commander (sold separately). For details on compatible remote
commander, visit the Sony web site in your area, or consult your Sony dealer or local authorized Sony service facility.
Select MENU →
(Network) → [Bluetooth Settings] → [Bluetooth Function] → [On] in advance. Refer to the
instruction manual for the Bluetooth remote commander as well.
This function can be used when the camera’s system software (firmware) is Ver.2.00 or later.
Menu item details
On:
Enables Bluetooth remote commander operation.
Off:
Disables Bluetooth remote commander operation.
Hint
The Bluetooth connection is only active while you are operating the camera using the Bluetooth remote commander.
You can execute a function assigned to the
(Enter) button on the camera by pressing the C1 button on the Bluetooth remote
commander.
When [Focus Mode] is set to [Manual Focus] or [Preset Focus], you can operate the camera as follows using the focus buttons
(+/-) on the Bluetooth remote commander.
This feature is only available for Bluetooth remote commanders equipped with focus buttons.
In the [Manual Focus] mode: Fine adjustment of the focus
In the [Preset Focus] mode: Turning the [NEAR Mode in PF] function on/off
If the function does not work properly, check the following notes and then try pairing again.
Confirm that the camera is not connected with other devices using the Bluetooth function.
Confirm that [Airplane Mode] for the camera is set to [Off].
Execute [Reset Network Set.] of the camera.
Note
On the camera, select MENU → (Network) → [Bluetooth Rmt Ctrl] → [On].
If there is no Bluetooth device currently paired with the camera, the screen for pairing as described in Step 2 will
appear.
1
On the camera, select MENU →
(Network) → [Bluetooth Settings] → [Pairing] to display the screen for
pairing.
2
On the Bluetooth remote commander, perform pairing.
For details, refer to the instruction manual for the Bluetooth remote commander.
3
On the camera, select [OK] on the confirmation screen for the Bluetooth connection.
Pairing is complete, and you can now operate the camera from the Bluetooth remote commander. After pairing
the device once, you can connect the camera and the Bluetooth remote commander again in the future by
setting [Bluetooth Rmt Ctrl] to [On].
4
