618313
60
Zoom out
Zoom in
Previous page
1/70
Next page
60
If you are charging the device during data transfer
and the computer enters sleep mode, standby
mode or hibernation, the device will be unable to
charge, and the battery may drain. When charging
the device via computer, confirm that your
computer is on, and completely charge the device
before using it.
Touchscreen
The Digital Paper device does not wake up or start
immediately.
When using the device in an environment that is too
cold, the screen may change at a slower speed.
Use the Digital Paper device within the
recommended temperature range of 5 °C (41 °F) to
35 °C (95 °F).
The touchscreen does not respond.
Reset the device (page 58).
Characters are not displayed.
Some user-defined characters or special symbols
may not be displayed.
The touchscreen responds slowly.
If the touchscreen becomes dirty, it may not
function correctly. Clean the touchscreen with a soft
cloth, such as a cleaning cloth for eyeglasses.
Cannot pinch in or out.
The touchscreen may not respond if other fingers
are in contact with the screen.
The stylus tip position and the mark it makes are
offset
Check the pen grip style settings. Press the
(Home) button, tap [Settings] [System
Management] [Pen Settings] [Pen Grip Style] to
check the settings.
Adjust the position of the stylus tip. Press the
(Home) button, tap [Settings] [System
Management] [Pen Settings] [Advanced
Calibration] to check the settings.
Wireless Connectivity
Wi-Fi connection
The Digital Paper device does not connect to the Wi-
Fi network.
The network feature could not be turned on
because the remaining battery power is too low.
Charge the device for a few minutes, then try again.
Make sure that Wi-Fi is turned on and check the
signal strength of the access point.
Tap [Wi-Fi Settings] [Scan] to select an available
access point.
Make sure that the security method (WEP, WPA/
WPA2 PSK, 802.1x EAP), the static IP address and the
proxy settings are correct.
The access point is using an unsupported security
method or encryption key.
Public Wi-Fi networks may require a user ID and
password. In this case, you must enter a correct user
ID and password to establish a network connection.
The access point has the MAC address filter
enabled. To check the MAC address, press the
(Home) button tap [Settings] [About] [Device
Information]. Make sure that this MAC address is
accepted by the access point.
The Wi-Fi network settings of the access point are
not correct. Adjust the settings as described in the
manuals that came with the access point and in any
information provided by the network administrator.
The device is too far from the access point. Move it
closer to the access point and scan again.
Obstacles such as walls, metal or concrete between
the device and an access point may adversely affect
the connection. Try moving the device to a different
location and scan again.
There is other equipment nearby using the 2.4 GHz
frequency band (such as a cordless phone, a
microwave oven, or Bluetooth computer
equipment). Move the equipment away or turn it
off.
The Wi-Fi network service is temporarily not
available or degraded. Check with the network
administrator for the status.
60


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony DPT-S1 - Digital Paper System at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony DPT-S1 - Digital Paper System in the language / languages: English as an attachment in your email.

The manual is 3,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info