291171
76
Zoom out
Zoom in
Previous page
1/212
Next page
Störungsbehebung
76
Störungsbehebung
Störungsbehebung
Wenn an Ihrem Camcorder Störungen
auftreten, versuchen Sie bitte, diese anhand
der folgenden Tabelle zu beheben. Wenn sich
das Problem nicht beheben lässt, trennen Sie
das Gerät von der Stromquelle und wenden
Sie sich an Ihren Sony-Händler.
Wenn auf dem LCD-Bildschirm oder im
Sucher „C:ss:sserscheint, wurde die
Selbstdiagnose ausgeführt. Weitere
Informationen finden Sie auf Seite 82.
Allgemeines
Akku/Stromquellen
Symptom Ursache und/oder Abhilfemaßnahmen
Das Gerät lässt sich nicht einschalten. Der Akku ist entladen, schwach oder nicht am Camcorder angebracht.
cBringen Sie einen geladenen Akku am Camcorder an. (S. 12)
cSchließen Sie das Netzteil an eine Netzsteckdose an. (S. 14)
Der Camcorder funktioniert nicht,
obwohl er eingeschaltet ist.
csen Sie das Netzteil vom Stromnetz oder nehmen Sie den Akku ab und
schließen Sie das Netzteil bzw. den Akku nach etwa 1 Minute wieder an.
Wenn der Camcorder immer noch nicht funktioniert, drücken Sie mit
einem spitzen Gegenstand die Taste RESET. Wenn Sie die Taste RESET
drücken, werden alle Einstellungen, einschließlich der Uhrzeit,
zurückgesetzt.
Beim DCR-HC18E/HC20E:
Die mitgelieferte Fernbedienung
funktioniert nicht.
cSetzen Sie [FERNBEDIEN] im Menü (SONSTIGES) auf [EIN].
(S. 62)
cLegen Sie eine Batterie in das Batteriefach ein. Die Pole +/– müssen an
den Markierungen +/– ausgerichtet sein. Wenn sich das Problem dadurch
nicht beheben lässt, legen Sie eine neue Batterie ein, da die Batterie
erschöpft ist. (S. 102)
cEntfernen Sie gegebenenfalls Hindernisse zwischen der Fernbedienung
und dem Fernbedienungssensor.
Der Camcorder erwärmt sich. Dieses Phänomen tritt auf, wenn der Camcorder lange Zeit eingeschaltet
bleibt. Dies ist keine Fehlfunktion.
Symptom Ursache und/oder Abhilfemaßnahmen
Die Ladeanzeige CHG leuchtet nicht,
während der Akku geladen wird.
cBringen Sie den Akku richtig am Camcorder an. Leuchtet die Anzeige
immer noch nicht, bedeutet dies, dass von der Netzsteckdose kein Strom
eingeht.
Das Laden des Akkus ist abgeschlossen. (S. 12)
Die Ladeanzeige CHG blinkt,
während der Akku geladen wird.
cBringen Sie den Akku richtig am Camcorder an. Wenn das Problem
bestehen bleibt, lösen Sie das Netzteil von der Netzsteckdose und
wenden Sie sich an Ihren Sony-Händler. Der Akku ist möglicherweise
beschädigt. (S. 12)
76


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony dcr-hc16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony dcr-hc16 in the language / languages: German, Dutch as an attachment in your email.

The manual is 5,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info