166931
29
Zoom out
Zoom in
Previous page
1/158
Next page
29
Troubleshooting
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
General
No sound.
•Press (VOL) (+) to adjust the volume.
Cancel the ATT function.
Set the fader control to the centre position for
a 2-speaker system.
The contents of the memory have been
erased.
The RESET button has been pressed.
t Store again into the memory.
The power cord or battery has been
disconnected.
The power connecting cord is not connected
properly.
No beep sound.
The beep sound is cancelled (page 22).
Indications disappear from/do not appear in
the display.
The clock display disappears if you press
(OFF) for 2 seconds.
t Press (OFF) again for 2 seconds to
display the clock.
Remove the front panel and clean the
connectors. See “Cleaning the connectors”
on page 26.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the ignition key is in the
ON, ACC, or OFF position.
The leads are not matched correctly with the
car’s accessory power connector.
No power is being supplied to the unit.
Check the connection. If everything is in
order, check the fuse.
The car does not have an ACC position.
t Press (SOURCE) (or insert a disc) to turn
on the unit.
The power is continuously supplied to the
unit.
The car does not have an ACC position.
The power aerial does not extend.
The power aerial does not have a relay box.
CD/MD playback
A disc cannot be loaded.
Another CD is already loaded.
The CD is forcibly inserted upside down or
in the wrong way.
Playback does not begin.
Defective MD or dirty CD.
CD-R/CD-RW that is not finalized.
You tried to playback a CD-R/CD-RW not
designed for audio use.
Some CD-Rs/CD-RWs may not play due to
its recording equipment or the disc
condition.
A disc is automatically ejected.
The ambient temperature exceeds 50°C.
The operation buttons do not function.
CD will not be ejected.
Press the RESET button.
The sound skips from vibration.
The unit is installed at an angle of more than
60°.
The unit is not installed in a sturdy part of
the car.
The sound skips.
Dirty or defective disc.
Cannot turn off the “--------” indication.
You may be in the name edit mode.
t Press (LIST) for 2 seconds.
Radio reception
Preset tuning is not possible.
Store the correct frequency in the memory.
The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
Connect a power aerial control lead (blue) or
accessory power supply lead (red) to the
power supply lead of a car’s aerial booster.
(Only if your car has built-in FM/MW/LW
aerial in the rear/side glass.)
Check the connection of the car aerial.
The auto aerial will not go up.
t Check the connection of the power aerial
control lead.
Check the frequency.
When the DSO mode is on, the sound is
sometimes hampered by noises.
t Set the DSO mode to off (page 24).
Automatic tuning is not possible.
The local seek mode is set to “on.
t Set the local seek mode to “off” (page
23).
The broadcast signal is too weak.
t Perform manual tuning.
The “ST” indication flashes.
Tune in the frequency accurately.
The broadcast signal is too weak.
t Set to the monaural reception mode (page
23).
continue to next page t
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony cdx m 730 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony cdx m 730 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 5,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info