50003
68
Zoom out
Zoom in
Previous page
1/112
Next page
67
Advanced Operations / Дополнительные операции
To write the RC time code from the
end of the RC time code recorded
portion
Rewind the tape to the portion on which the RC
time code has been written and set the camcorder
to playback pause mode. Then follow steps 3 and
4 above. The RC time code is written
continuously.
Notes on writing the RC time code
The RC time code writing stops when:
you press TIME CODE WRITE again before
starting playback.
you press INDEX or DATE before starting
playback.
you change from playback mode to another
mode.
When you are writing the RC time code from
the middle of a tape without the time code
written, writing starts several frames before the
current picture.
If you write the RC time code on a recorded
tape, the Data Code is erased.
You can mark the RC time code on a tape
recorded both in LP mode and SP mode, the RC
time code written in LP mode, however, may
not be read correctly.
You cannot mark the RC time code on an
NTSC-recorded tape.
You cannot write the RC time code on a tape
with the red mark on the cassette exposed.
A black band appears when you mark the RC
time code during playback, and the sound
cannot be heard. This does not affect the picture
and sound that are already recorded.
Note on --:--:--:-- indicator
The --:--:--:-- indicator appears during playback
if:
nothing is recorded.
the RC time code is unreadable because of the
damage of the tape or because of the noise.
you recorded using another VCR without RC
time code function.
you erase the index signal or make PCM after
recording on another VCR in the portion on
which the RC time code is written.
In this case, we recommend you to rewrite the
RC time code.
Ввод временного кода RC с конца
записанной части кода
Перемотать ленту назад до части, на которой
записан временной код RC, и установить
видеокамеру в режим паузы
воспроизведения. Затем выполнить
вышеуказанные операции по пп.3 и 4.
Временной код RC вводится непрерывно.
Примечания по вводу временного кода RC
Ввод временного кода RC остановится в
том случае, когда:
Вы нажмете на кнопку TIME CODE WRITE
(Ввод временного кода) повторно перед
началом воспроизведения;
Вы нажмете на кнопку INDEX (индекс) или
DATE (Дата) перед началом
воспроизведения;
Вы переключите режим произведения на
другой.
При введении временного кода RC с
середины ленты, на которую не введен код,
начнется ввод с нескольких кадров
изображения перед текущим.
При введении временного кода RC на
записанную ленту код данных сотрется.
Возможно отметить код времени RC на
ленте, записанной как в режиме LP, так и в
режиме SP, но бывают случаи, когда
записанный в режиме LP код времени RC
не показывается правильно.
Невозможно отмечать временной код RC на
ленту, записанную по системе NTSC.
Невозможно ввести временной код RC на
ленту с выявленной красной отметкой на
кассете.
Черные полоски появляются при отметке
кода времени RC во время
воспроизведения, и звук отсутствует. Но,
это не оказывает влияния на качество
изображения и звучания выполненной
записи.
Примечания по индикации --:--:--:--
Индикация --:--:--:-- появится при
воспроизведении в случае, если:
Ничего не записано.
Временной код RC не считывается из-за
повреждения ленты или помех.
Видеозапись выполнена с применением
другого видеомагнитофона, не имеющего
функции временного кода RC.
Вы стерли индексный сигнал или выполнили
ипульсно-кодовую модуляцию (ИКМ) после
записи на другом КВМ в месте, на котором
записан код времени RC.
В этом случае рекомендуется выполнить
повторно запись кода времени RC.
Writing the RC Time code on a
recorded tape
Ввод временного кода RC в
видеозапись
68


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony CCD-TR820E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony CCD-TR820E in the language / languages: English as an attachment in your email.

The manual is 2,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sony CCD-TR820E

Sony CCD-TR820E User Manual - German - 112 pages

Sony CCD-TR820E User Manual - Dutch, French - 112 pages

Sony CCD-TR820E User Manual - Italian - 112 pages

Sony CCD-TR820E User Manual - Portuguese, Spanish - 112 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info