703524

Sonnenkonig WARMEPILZ CHROM GAS Manual

51
Zoom out
Zoom in
Previous page
1/60
Next page
51
4 Leak test
5 Operation and storage
Gas connections on the heater are leak tested at the factory prior to shipment. A com-
plete gas tightness check must be performed at the installation site because of possible
mishandling in shipment or excessive pressure being applied to the heater.
• Make a soap solution of one part liquid detergent and one part water. The soap solu-
tion can be applied with a spray bottle, brush or rag. Soap bubbles will appear in case
of a leak.
• The heater must be checked with a full cylinder.
• Make sure the safety control valve is in the OFF position.
• Turn the gas supply ON.
• In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the gas
supply on and recheck.
• Never leak test while smoking!
To turn on the heater:
1. Turn on the valve on the gas supply cylinder completely.
2. Press and turn the control knob to PILOT position (counter-clockwise 90°).
3. Press and hold the control knob for 30 seconds. While holding down the control knob,
press the igniter button several times until the pilot flame lights. Release the control
knob after the pilot flame has lighted up.
• If a new tank has just been connected, please allow at least one minute for the air in
the gas pipeline tp purge out trough the pilot hole.
• When lighting the pilot flame make sure that the control knob is continuously held
down while pressing the igniter button. The control knob can be released after the
pilot flame lighted up.
• Pilot flame can be watched and checked from the small round window with sliding lid
located at the bottom of the flame screen (to the left or right side of the controller).
• If the pilot flame does not light or goes out, repeat step 3.
4. After the pilot flame has lighted up, turn the control knob to maximum position and
leave it there for 5 minutes or more before turning the knob to the to desired tempe-
rature position.
GB
… 51 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sonnenkonig WARMEPILZ CHROM GAS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sonnenkonig WARMEPILZ CHROM GAS in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 2,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info