703461
46
Zoom out
Zoom in
Previous page
1/52
Next page
46
3 Operating instructions
General information
The heater must be placed on a flat table or on the floor.
Before moving the heater, unplug it from the wall outlet and wait for it to cool down completely. When moving it,
remember not to pull the power cord directly to avoid damaging the unit.
It is forbidden to cover the heater or bake on it in the event of a fire disaster.
Because improper manipulations and arrangements can cause a fire, you cannot start this heater with a programmer
with an automatically connected power source, timer, or similar device.
If the heater is to be protected for an extended period of time, it is important to first turn off the power switch and then
disconnect the power plug.
This product should not be used next to curtains or other indoor furniture. It is recommended to leave more than half
the area in place.
50 cm from the wall and furniture without obstacles 50 cm above, which can facilitate air circulation.
This product is intended for indoor use only. Please do not use it outdoors.
This product should not be used or stored for long periods in damp or dusty locations for fear of accidents such as
external corrosion, power failure due to moisture and electric shock.
If you plan to clean the heater, first unplug it and wait for it to cool down completely.
This product is prohibited in flammable, explosive, and greasy situations, and the ambient temperature should not
exceed the ambient temperature.
30° C must not be exceeded.
This heater must not be used in bathrooms or swimming pools.
Do not touch the mains switch and do not pull the mains plug with wet hands in the event of an electric shock.
Do not bend, pull, or knot the power cord to avoid excessive heat.
If the power cord is damaged, it must be replaced by a service technician from the manufacturer or its service depart-
ment for safety reasons.
Please plug the plug into a 220V~, 50Hz/60Hz, 5A outlet before use to maintain power to the product.
When the ON/OFF button is pressed for the first time, the heater and the PTC heating element are started and the warm
air is blown out evenly.
The second press of the ON/OFF button allows the appliance to continue running for 15 seconds before switching off.
Manual for hand warmer
Place the hand warmer on the middle air outlet of the appliance.
Press the ON/OFF button to start the heater.
Remove the hand warmer from the appliance after 45 minutes.
The hand warmer has now stored the heat for 40 minutes and emits it continuously.
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sonnenkonig BEE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sonnenkonig BEE in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info