680782
36
Zoom out
Zoom in
Previous page
1/88
Next page
36
S10931-00001_Rev-D_EN
6. Installation
4. Transfer the mounting points to the substructure.
Drill two holes (Ø 6 x 40 mm deep).
Insert the two wall plugs.
Affix the wall control unit with two screws and two
washers, align the unit and firmly tighten the screws.
Press the end caps into the indentation to seal the
housing.
5. Route the control cable of the plug-in unit up to the
wall control unit and secure to prevent displacement.
50 mm
90 mm
Fig. 6 Fig. 7
6. Lay the control cable along the cable conduit on the
rear side of the wall control unit up to the cable inlet.
Feed the control cable into the wall control unit
through the cable inlet.
7. Shorten the control cable to no less than 140 mm in
length, uncover the last 50 mm and strip the wires.
gn
rt
Fig. 8 Fig. 9
8. Route the control cable in the wall control unit along
the transformer up to the gr/rd terminal.
Secure the control cable with the upper strain relief
to prevent displacement.
9. Connect the green wire of the control cable to the gn
terminal.
Connect the red wire of the control cable to the rd
terminal.
10. Close the housing in reverse order.
Installation of the wall control unit is complete.
Other connection options such as buttons or warning light
are described in chapter "11. Connections and special
functions of the wall control unit."
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sommer S 9080 pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sommer S 9080 pro in the language / languages: English as an attachment in your email.

The manual is 10,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sommer S 9080 pro

Sommer S 9080 pro User Manual - German - 88 pages

Sommer S 9080 pro User Manual - Dutch - 88 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info