9
• Slide the trolley (1) into the C-rail (2).
• Connect two C-rails (1) by inserting them to the stop in the slide-on
module (2).
• Attach tensioner (1) to chain (2) and turn it by 90°.
Mount slide-in module (6) and push tensioner (1) through it.
Place washer (5) and spring (4) onto the tensioning bolt (3) and
screw it into the tensioner (1).
• Tighten chain until the mark (arrow) is reached.
• Do not tighten on this side, as the unit is supplied pre-tensioned.
7
6
Selection of installation option
Select the desired installation option. For option (A), change the
position of power supply unit.
Pre-assembly for installation option A
Dispose of packaging material according to the applicable
statutory regulations.
• Remove the drive system from packaging.
• Release the switch trigger (1) and move it in the direction of the
arrow. Open the chain case (2).
• Slide the trolley (1) onto the chain (2) with the chain case (4). The
chain (2) engages in the chain wheel (3). If the chain wheel (3) does
not turn, pull the emergency release (N) once. The chain wheel (3) is
released.
2