474216
12
Zoom out
Zoom in
Previous page
1/32
Next page
Installation
12
9
S
30
min.15
30
15
15
D
½
½
½
½
½
½
VM
VM
VM
10
NOTE!
If installing on the ceiling (D), space the drill holes 15 mm apart
if possible. Reduced tilting angle of the mounting bracket.
The drive can be mounted on the header (S) or on the ceiling (D).
Measure the front of the center of the door (VM) and mark on the door
and header or ceiling.
15
½
½
½
½
HMHMHM
12
VM
74 mm 74 mm
10 mm
65 mm
11
THP
Make a mark 74 mm to the right and left of the center of the door (VM)
and fasten at the same height on the header or ceiling (as per picture 9).
Drill two holes (Ø 10 x 65 mm deep).
NOTE!
Wear safety glasses while drilling.
Take into account the thickness of the ceiling, especially
with regard to prefab concrete garages!
Open the door. Project the mark from the center of the door to the
ceiling (HM). Close the door.
NOTE!
Protect the controller housing (6) against damage.
13
2
6
4
5
31
FRO
NT
V
OR
N
E
Insert anchor ttings (1). Lift the drive (2) at the front. Tightly fasten
header tting (3) at the front with two bolts (4) and U-washers (5).
15
1
HM
3
2
5
4
B
600
0
1
14
ATTENTION!
Always ensure that the drive is installed parallel to the
running rails of the door.
HM
Raise the drive.
Align the ceiling suspension bracket (1). The position should be in the
range of (W = 0 …600 mm).
Align the drive horizontally to the rear of the center of the door (HM).
Mark the drill holes. Drill two holes (Ø 10 x 65 mm deep).
NOTE!
Wear safety glasses when drilling. Take the thickness of the
ceiling into consideration, especially with regard to prefab
concrete garages.
Insert anchor ttings (1). Place U-washers (3) under the two bolts (2).
Firmly tighten the bolts (2).
Vertically align C-rails (4), e.g. with a spirit level. If required by this,
reposition the bolts (5). Tighten the bolts (5).
16
2
3
5
4
3
N
1
FR
O
N
T
VO
R
N
E
2
48
7
3
6
5
1
N
17
NOTE!
Choose suitable bolts depending on what the door is made of.
Wear safety glasses when drilling!
Install the push rod (1):
Insert the bolts lengthwise (2) and slide on the clamp (3).
Brie y fasten door bracket tting (4) to the push rod (1) with bolts (5)
and slide on the clamp (3).
Pull once on the emergency unlocking cord (N). The carriage (1)
is unlocked. Tighten the bolt (8) on the header tting.
Slide the carriage (1) all the way to the front (3) with the push rod (2).
Loosen the guide idler (4) if necessary to do this.
Align the door bracket tting (5) with the center of the door (VM) and
mark 5 drill holes. Drill 5 holes (Ø 5 mm).
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sommer Marathon 1100SL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sommer Marathon 1100SL in the language / languages: English as an attachment in your email.

The manual is 4,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sommer Marathon 1100SL

Sommer Marathon 1100SL User Manual - German - 32 pages

Sommer Marathon 1100SL User Manual - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info