680563

Sommer Duo vision 800 Manual

3
Zoom out
Zoom in
Previous page
1/30
Next page
– 3
t
Symbols
ATTENTION SYMBOL:
Important safety instructions!
Attention - to ensure personal safety, it is important to
observe all instructions. Save these instructions!
NOTE SYMBOL:
Information, useful advice!
Refers to a respective picture in the introduction or main text.
Safety instructions
General
¾ These installation and operating instructions must be read, understood
and complied with by persons who install, use or perform maintenance
on the drive.
¾ Installation, connection and initial commissioning of the drive may only
be carried out by technically knowledgeable persons.
¾ All lines are to be rmly secured, for example, against moving.
¾ Only install the drive on correctly aligned and weight-balanced doors.
An improperly aligned door can cause serious injuries or damage the
drive.
¾ The manufacturer assumes no liability for injuries, damage or break-
downs that occur due to non-compliance with the installation and
operating instructions.
¾ Ensure that these installation and operating instructions are kept in an
easily accessible location within the garage.
¾ Always ensure compliance with accident prevention regulations and
current standards in each respective country.
¾ Follow and comply with the “ASR A1.7 Technical Regulations for
Workplaces” of the committee for workplaces (ASTA). (Applies to
operators in Germany.)
¾ Always disconnect the mains plug before working on the drive.
¾ Only use OEM (Original Equipment Manufacturer) spare parts,
accessories and mounting material.
Storage
¾ The drive must be stored indoors in an enclosed, dry area at a room
temperature of –20 - +50 °C.
¾ The drive should be stored horizontally.
+50°
20°
Operation
¾ The drive may only be operated if a non-hazardous force value has
been set. This force value must be set low enough to ensure that the
closing force poses no risk of injury.
¾ Never put your hand near the door when it is moving or near moving
parts.
¾ Continuously monitor the door while it is in motion and keep all persons
away from it until the door is completely opened or closed.
¾ Only pass through the door only once it is completely open.
¾ Actuating the emergency release can lead to uncontrolled door
movements if springs are weakened or broken, or if the door has not
been optimally weight-balanced.
¾ There is a risk of persons being crushed or cut by the mechanism or
sharp edges of the door.
¾ If the garage does not have a separate entrance or the garage door
does not have a built-in slip door, you must install an emergency
release (release lock or Bowden cable) that can be operated from
outside.
Radio remote control
¾ The remote control must only be used for devices and systems in which
radio interference will not endanger people, animals or objects, or the
risk is reduced by other safety devices.
¾ The user must be made aware that systems that pose an accident risk
should only be operated – if at all – by remote control if the user can
actually see the door.
¾ The radio remote control may only be used if the door’s movement
can be watched and no persons or objects are within the range of
movement.
¾ Store the hand-held transmitter so that unintended operation, e.g.,
by children or animals, is impossible.
¾ The operator of the radio system is not protected from faults due to
other telecommunications equipment or devices (e.g. radio-controlled
systems that are licensed to operate in the same frequency range).
If substantial interference occurs, please contact your appropriate
telecommunications ofce which has radio interference measuring
equipment (radiolocation).
¾ Do not operate the hand-held transmitter in areas with sensitive radio
communications or systems (e.g. airports, hospitals).
Type plate
¾ The type plate is located on the cover of the controller housing.
¾ The type plate shows the exact type designation and the date of
manufacture (month/year) of the drive.
Intended use
CAUTION! RISK OF IRREPARABLE DAMAGE TO THE DRIVE!
Do not open or close doors with the drive unless the
counterbalance is properly adjusted (springs tensioned).
Otherwise, you will damage or destroy the motor
(transmission).
CAUTION! RISK OF DEATH!
Remove all cords or straps necessary to operate the door
by hand.
¾ The drive is intended exclusively to open and close doors. Any other
use does not constitute intended use. The manufacturer accepts no
liability resulting from use other than intended use. The user bears the
sole responsibility for any risk involved. It also voids the warranty.
¾ Doors automated with an operator must must comply with the valid
standards and directives: e.g. EN 12604, EN 12605.
¾ The drive may only be used if it is in perfect working order and is used
as intended, in conscious observation of safety and hazards and in
accordance with the installation and operating instructions.
¾ Malfunctions which could affect safety must be corrected immediately.
¾ The door must be stable and rigid, meaning that it may not bend or
twist when being opened or closed.
¾ The drive cannot compensate for defects in the door or incorrect
assembly or installation.
¾ Only use the drive in a dry, non-hazardous area.
¾ Do not install the drive in areas with a corrosive atmosphere
(e.g. salty air).
General Information
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sommer Duo vision 800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sommer Duo vision 800 in the language / languages: English as an attachment in your email.

The manual is 6,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sommer Duo vision 800

Sommer Duo vision 800 Usermanual and installation guide - German - 30 pages

Sommer Duo vision 800 Usermanual and installation guide - Dutch - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info