680564
21
Zoom out
Zoom in
Previous page
1/30
Next page
Operation / Use
t
– 21
The light bulb behaves differently depending on the DIP switch:
DIP switch 4 ON,
light bulb (2) lights up after the controller reset.
DIP switch 4 OFF,
light bulb (2) blinks after the controller reset.
NOTE!
After a controller reset, the drive must be reprogrammed.
Intermediate stop
An intermediate stop, caused by actuating a button or hand-held remote
control, immediately stops the drive. At the next command the drive moves
in the opposite direction; see chapter “Operation/use - pulse sequence of
door movement”.
Safety stop 1
(power cut-off)
For a power cut-off, the drive stops or reverses. At the next command the
drive moves in the opposite direction; see chapter “Operation/use - pulse
sequence of door movement”.
Safety stop when closing the door: the door reverses.
Safety stop when opening the door: the door stops.
Safety stop 2
(safety input)
When the safety input is triggered (e.g. if someone has gone across the
photo eyes), the drive stops, reverses or opens depending on the setting of
the DIP switches.
Explanations of and setting options for the DIP switches can be found in the
chapter “Functions and connections - obstacle detection”.
Factory settings: DIP switches 1 and 3 OFF:
Door reverses if safety input is triggered while the door is closing.
If the safety input is activated while the door is opening, there is no
reaction (the door continues to open).
Overload protection
If the drive is overloaded during opening or closing, the control system
detects it and stops the drive. After about 20 seconds or a control system
reset, the control system releases the overload protection again.
The drive can now resume operation.
Operation after a power failure
The programmed force values are retained in the event of a power failure.
The rst movement of the drive after a power failure is always door OPEN.
Radio receiver
HOMELINK-COMPATIBLE!
If your vehicle is equipped with a HomeLink system
(Version 7), our drive and radio receiver with 868.6 MHz are
compatible. Another radio frequency (40.685 or 434.42 MHz)
must be used with older HomeLink systems. For information
see: “http://www.eurohomelink.com”
Safety instructions
¾ The local safety regulations for the system must be complied with to
ensure safe operation. Information is available from electric power
providers, industry associations (such as the German VDE) and
employers' liability insurance providers.
¾ The operator is not protected against interference caused by other
telecommunications equipment or devices (e.g. wireless systems which
are being operated properly in the same frequency range).
¾ Replace the hand-held transmitter unit's batteries if you experience
reception problems.
Display and button explanation
5
2
6
4
3.1
3.2
1
2
1
ON
DI
P
3
4
5
6
87
8
9
10
11
12
7
1
Learn button - sets the radio receiver in different operating modes:
Learn mode
Delete mode
Normal mode
2
Internal antenna
3
LEDs - show which channel has been selected.
3.1 LED channel 1
3.2 LED channel 2
4
Connection for an external antenna
An external antenna (6) can be used if the range with the internal
antenna is insufcient.
5
Hand-held transmitter button
6
External antenna
7
Optional: an external radio receiver can be connected in the
housing (special accessory)
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sommer Duo rapido 650 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sommer Duo rapido 650 in the language / languages: English as an attachment in your email.

The manual is 6,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sommer Duo rapido 650

Sommer Duo rapido 650 Usermanual and installation guide - German - 30 pages

Sommer Duo rapido 650 Usermanual and installation guide - Dutch - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info