814896
28
Zoom out
Zoom in
Previous page
1/97
Next page
24
The same chimney should not be used for more than one appliance or open fireplace.
In the collective chimneys each one must reach the windows that must be at the same
level, independently, so that the air circulation expels the gases out.
If the chimney is brick it should not be too wide, because the smoke when spreading
cools and damages the draw. In case of difficulty in the draw, due to contrary winds, a hat
should be applied, according to what is most favorable.
6.2. Installation location requirements
The floor where the stove will be installed must allow a permanent load of 1 kg/cm².
If the load capacity of the floor is not sufficient, a rigid plate may be used for the
distribution of the load over a surface greater than that of the support of the recuperator.
Near the walls of the recuperator cannot be used combustible materials.
The dimensions of the insertion space of the recuperator must comply:
- 15 cm between the side walls of the stove and the walls of the space.
- 5 cm between the back wall of the stove and the wall of the space.
If there are significant and undesirable heat exchanges through the walls of the
insertion space, it is advisable to proceed with thermal insulation that minimizes losses.
The nominal characteristics power "water" and power "environment" are only verified in
conditions of thermal insulation of the walls of the recuperator.
The ornamental stones must have a distance from the equipment of about 5 mm, to
allow the expansion of the metallic material, as well as must be installed so that the
recuperator can be removed, without damaging it, in case of any anomaly;
The materials present in front of the recuperator must be able to withstand heating by
radiation effect through the glass of the equipment, and must not, therefore, have
combustible characteristics.
In the sealing of the chimney should be applied a refractory material - refractory
cement or other.
The use of wood in the finishes may have the inconvenience of fire risk, so we advise
its proper insulation or its non-use.
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solzaima ECOFOGO ECO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solzaima ECOFOGO ECO in the language / languages: English as an attachment in your email.

The manual is 3.81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info