655794
24
Zoom out
Zoom in
Previous page
1/97
Next page
Maintenance and care
ENGLISH 8
6. Maintenance and care
Any cleaning, maintenance or repair jobs should
only be performed when the engine is stopped and
with removed spark plug cap.
Any service jobs, other than those described in
this manual, should only be carried out by an
authorized service center. Only original parts may
be used for any maintenance and service work.
Never modify your motorized mistblower – your
personal safety is at risk.
Never service or store the machine near an open
flame.
Regularly check the fuel tank lid for sealing and
tank ventilation. Only use recommended spark
plugs. Check ignition cable for any damage.
After a running in period of approx. 5 hours, all
accessible screws and nuts (except for carburetor
mixture adjustment needles) have to be checked
and re-tightened if required.
Never operate a motorized mistblower with a
damaged muffler or without muffler (fire risk and
risk of damage to hearing). Do not touch hot
muffler.
6.1 Fuel tap
Remove the fuel cock at regular intervals to clean
the fuel strainer. - Make sure to keep the vent hole
of the fuel tank cap open at all times.
6.2 Formula Tank Lid
Watch seal of the spray tank lid and service by
lubricating the rubber gasket inside the lid. Failing
this, pressure built-up in the container is impaired
and dosage of emission becomes irregular.
6.3 Liquid Tap
Maintain the tap on a regular basis and apply oil or
grease. To disassemble the tap, twist the upper
part 1/4 turn to the left (anti-clockwise). Apply oil or
grease to the valve stem and o-ring, than re-
assemble. Replace o-ring if required.
6.4 Air Filter
The air filter separates and retains dirt before
the air reaches the combustion chamber. This
reduces engine wear.
Regular maintenance increases engine life.
Clogged air filters cause performance loss and
increased fuel consumption. This leads to a higher
toxin level in the exhaust gas and also makes
starting more difficult.
For daily cleaning:
Tap the air filter against an object or use an air
gun.
With heavy dust conditions and for normal weekly
check:
thoroughly clean the filter and replace filter if
damaged.
Cleaning of air filter
Before opening the air filter, close the choke to
prevent dirt entering the carburettor.
For removal of the air filter, remove filter cover
screw and filter cover.
When re-fitting, ensure the filter is positioned and
seated properly.
When the machine is used all day, the air filter
should be cleaned daily. In severe dust conditions
clean more often.
Simply tapping the filter against an object is the
best method of cleaning.
Wash a heavily soiled filter in non-flammable
cleaning solvents (warm soapy water).
Never insert moist or wet foam filters!
Immediately replace damaged filter parts.
Warranty claims cannot be accepted for damaged
engine parts caused by improper care and
maintenance.
6.5 Spark Plug
The correct spark plug with thermal range 145 is
available under the following brands:
BOSCH W8AC
The correct electrode gap is 0.5mm.
Caution: Check the plug after every 50
operating hours and replace if electrodes
are worn.
Fig. 2
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo Port 423 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo Port 423 in the language / languages: Dutch, Italian as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Solo Port 423

Solo Port 423 User Manual - English, German, French, Spanish - 62 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info