655959
61
Zoom out
Zoom in
Previous page
1/249
Next page
Preparing for use
ENGLISH 19
Mix table for fuel mix:
Instead of a self-produced fuel mix, you may also use a pre-mixed special fuel mix for two-stroke motors.
Recommendation: Use the special fuel mix of the brand "Aspen 2-stroke". The special fuel manufacturer's
information must be observed.
Models 881-12 and 881-14 with iLube
®
Models 881-12 and 881-14 are equipped with a fuel tank and an oil tank each that must be
filled according to the specification below
The fuel mix is automatically formed during operation in these models (separate lubrication,
iLube
®
, Intelligent Lubrication).
Fuel tank (18) for lead-free regular petrol or
lead-free super petrol with a minimum
octane number of 92 RON.
Do not fill any fuel mix into the fuel tank (18)!
Oil tank (19, green cap) for branded 2-stroke
engine oil corresponding to the standard
ISO-L-EGD or JASO FD.
Recommendation:
Use the "SOLO Profi 2-stroke engine oil".
If there is not enough oil in the oil tank, the
power tool will automatically reduce output
even in the lower speed area and will not
reach the speed required for work, which will
be noticed by changed noise generation as
compared to regular operation.
A
t this point at the latest, oil must be
refuelled.
Fill in operating media (fuel mix or petrol and oil)
Observe the safety provisions when fuelling up. Fuel up only with the motor switched off.
x Clean the fill-in area well.
x Put down the motor device so that the fuel tank cap points up.
x Unscrew the tank cap.
x To avoid contamination in the tank, use a screen funnel if possible.
x Fill the tank no farther than to the lower edge of the nozzle.
x Screw on the tank cap tightly again until the overturning protection clearly "skips".
x After fuelling up, clean any splashed operating medium from the power tool.
x Never start or operate the power tool at the site of fuelling.
Oil:petrol ratio = 1:50 (2 %)
Branded 2-stroke engine oil Petrol
20 ml 1 l
40 ml 2 l
100 ml 5 l
200 ml 10 l
18
19
61


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 880 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 880 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 2,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info