655955
69
Zoom out
Zoom in
Previous page
1/160
Next page
Operating and maintenance notes
ENGLISH 29
Maintenance and repairs of state-of-the-art power tools and their safety-relevant assemblies require
qualified specialist training and a workshop equipped with special tools and test devices.
Recommendation: Have all work not described in these operating instructions and all work you are not
comfortable with be performed by a specialist workshop authorised by us. The specialist has the required
training, experience and equipment and can make the most cost-efficient solution available to you. He will
advise and support you.
Observe the safety provisions for any maintenance work!
After a run-in time of approx. 5 operating hours, all screws and nuts that can be
reached (except for carburettor adjustment screws) must be checked for tight fit and
tightened again if required.
It is best to keep the power tool in a dry and safe site with a full fuel tank.
There must not be any open sources of fire or the like nearby.
Before extended storage (> 4 weeks), observe the notes in chap. 8.11, on page 38.
The power tool must be cleaned thoroughly after every use and checked for damage; in particular the
cooling air openings in the starter housing must be clean and free.
Inside the wheel guard, material deposits will form over time (in particular when wet cutting), which may
impair free rotation of the cut-off wheel.
Only use the environmentally compatible cleaning agents offered by specialist vendors for cleaning. Never
use fuel to clean!
x Disassemble cut-off wheel and outer mounting flange. Î Chap. 5.3, page 17
x Remove material deposits inside the wheel guard with a wood bar or similar.
x Clean spindle and all disassembled parts and check them for damage.
x Clean cut-off wheel and check it for damage. If any damage is found, dispose of the cut-off wheel
properly and immediately so that it is not reused in the next work deployment.
x Inspect the wheel guard for damage. If damaged, replace the wheel guard by an undamaged wheel
guard before using the power tool and dispose of the damaged wheel guard properly and immediately.
x Install outer mounting flange, any other parts and cut-off wheel again. Î Chap. 5.1, page 16
8 Operating and maintenance notes
8.1 Cleaning and care
69


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 879 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 879 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 2,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info