658842
35
Zoom out
Zoom in
Previous page
1/46
Next page
Operating and maintenance information - Carburettor settings
ENGLISH 35
E
N
G
8.2 Carburettor settings
The carburettor is preset to the optimum settings for the
device at the factory. Depending on the particular
location where the chainsaw is used (mountains, flat
country) it may be necessary to adjust the idling settings
via the idle stop screw "T" (24).
! The adjusting screws for the idling mixture "L" and
the full-load mixture "H" (25) must only be adjusted by
an authorised workshop.
When the idling settings are correct the engine should run smoothly at idle without the saw chain
being driven. Corrective adjustments to the average idle speed indicated in the technical data can be
made as follows via the idle stop screw "T" – ideally with the aid of a tachometer:
If the idle speed is too high (particularly if the saw chain is already driven without the throttle being
operated), slightly open up the idle stop screw "T" by turning it anti-clockwise.
If the idle speed is too low (i.e. the engine keeps stopping at idle), slightly close the idle stop
screw "T" by turning it clockwise until the engine runs evenly.
The saw chain must never be driven while the engine is idling.
If the idling speed cannot be set correctly with the idling end-stop screw "T", request an authorised
service centre to tune the carburettor.
The following instructions are for authorised service shops
D-CUT carburettors:
Use the D-CUT carburettor key to adjust the idle mixture screw "L" and the full load mixture screw
"H".
Information about the standard settings can be requested from the specialist workshop of our
customer service department or downloaded from our Internet portal for specialist dealers at
www.part-and-more.org.
Carburettors with limiter caps:
The regulating screws for idle mixture and full load mixture can only be adjusted in a limited
range.
Clean the air filter before adjusting the low speed screw!
Let the engine run warm before adjusting the engine speed.
The carburettor is tuned for optimum engine performance. Use a rev counter to tune the carburettor
correctly!
Do not adjust the engine to a higher speed. Excessive engine speed can lead to major engine
damage!
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 656SP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 656SP in the language / languages: English as an attachment in your email.

The manual is 1,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info