658842
32
Zoom out
Zoom in
Previous page
1/46
Next page
Operating and maintenance information - Maintenance and care of the cutting gear
ENGLISH 32
E
N
G
8. Operating and maintenance information
With modern equipment and safety-relevant components, maintenance and repairs must only be
carried out by persons with suitable specialist qualifications in a workshop equipped with the
necessary special tool and testing equipment. As a result, the manufacturer recommends that all work
which is not described in these operating instructions should be performed by a specialist workshop.
The experts have access to the training, experience and equipment which is required in order to
provide you with the most cost-effective solution. An expert can also offer invaluable advice.
Always follow all of the safety instructions when performing maintenance work!
After the device has been run in for around 5 operating hours, all accessible nuts,
bolts and screws (except the carburettor adjusting screws) should be checked for
tightness and retightened as required.
It is best to store the device in a dry and safe location with a full fuel tank. There must not be any
naked flames or similar nearby. If you plan to not use the chainsaw for a longer period (i.e. more than
four weeks), please refer to the information in chapter 8.10 "
Shutdown and storage”.
8.1 Maintenance and care of the cutting gear
Generall information saw chain
Every saw chain is matched to the relevant chainsaw type in terms of its form, cutting performance
and design. Only use the genuine SOLO saw chain which is approved for your chainsaw / guide bar
type.
The key distinguishing factors for the saw chain are:
The form of the cutting elements:
a) Solid bit (rectangular cutting tooth, professional chainsaws)
b) Half bit (half-round cutting tooth, semi-professional / hobby chainsaws)
The pitch:
This is the distance s (from one rivet to the next but one) divided by 2.
The pitch is quoted in inches.
The driving link thickness:
This is the thickness of the part of the driving link which protrudes in the
guide groove of the rail
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 656SP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 656SP in the language / languages: English as an attachment in your email.

The manual is 1,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info