658837
29
Zoom out
Zoom in
Previous page
1/46
Next page
Using the chainsaw - Cutting to length, - Cutting branches which are under tension
ENGLISH 29
E
N
G
7.1 Cutting to length
Make sure that you have a secure footing.
Clean the area which is to be cut of any foreign bodies like sand, stones, nails etc. Foreign bodies
can cause dangerous kickback.
Loose wooden objects must be firmly secured, ideally with a sawhorse.
The wood must nut be held in place with a foot or by another person.
Round timber must be secured so that they cannot rotate.
Release the chain brake,
Apply full throttle and move the chainsaw close
to the cutting point,
position and press the bumper spikes onto the
object you wish to saw (a),
then – and not before – use a pivoting
movement (around the point at which the
bumper spikes have been positioned) to move
the guide bar downwards (b) and start the cut.
(schematic diagram)
7.2 Cutting branches which are under tension
The increased tendency for the chainsaw to become trapped means that there is a greater
risk of kickback
[See also Chapter 6, "Hazards caused by kickback”]
.
First cut around ¼ of the diameter on the compression side (symbol: " # #), but be careful as
there is a risk of the saw being trapped.
Then proceed carefully and make a cut at the tension side (symbol: #
$ ").
On thick trunks which are under a lot of tension offset the cut to one side.
Trunk under tension
on the upper side:
Danger: The tree
will spring back in
an upward direction!
Trunk under tension
on the underside:
Danger: The tree
will spring back in
a downward direction!
Thick trunks and high
tension:
Danger: The
tree will spring
back suddenly and
with considerable
force. Also watch out
for the root clump
tipping back.
Trunk under lateral
tension:
Danger: The
tree will spring
back to one side!
Always stand on the compression side if the tree is under lateral tension.
If the saw becomes pinched in the cut, stop the engine and lift the trunk with a bar or other lever, or
change its position to open up the cutting gap.
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 651 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 651 in the language / languages: English as an attachment in your email.

The manual is 1,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info