658836
9
Zoom out
Zoom in
Previous page
1/46
Next page
Safety regulations - Beim Zusammenbau, Reinigung, bei Wartung und Reparatur, Before starting the tool
ENGLISH 9
E
N
G
2.6 During assembly, cleaning, maintenance and repair
The power tool must not be assembled, maintained, repaired or stored in the vicinity of naked
flames.
The engine must be switched off and the stop switch set to "Stop“ for the duration of all work
performed on the guide bar and saw chain (for assembly, cleaning, maintenance and repairs)
(ideally the spark plug connector should be unplugged as well). Always use protective gloves.
The power tool requires regular maintenance. Only perform maintenance or repairs yourself if the
relevant operations are covered in the operating instructions. All other work should be performed
by an authorised specialist workshop.
During maintenance of the silencer or when checking that the silencer is firmly positioned, never
touch the silencer if it is still hot – risk of burns! The silencer gives off extremely large amounts of
heat.
Only genuine replacement parts supplied by the manufacturer must be used for any repairs.
No changes must be made to the power tool, as this could affect the safety of the device and
increase the risk of accident or injury.
2.7 Before starting the tool
Check the tool every time before starting it to make sure that the complete power tool is operationally
safe. The following points should be checked in addition to the points listed in the operating and
maintenance instructions (chapter 8):
The stop switch must be easy to switch.
The throttle control must move freely and return automatically to the idle position. If the throttle
control is operated while the choke lever is pressed in then this must cancel any part throttle stop
that is set.
The guide bar must be firmly secured. Always check that the chain has the correct tension and
adjust the tension if required before starting the tool.
Also check that the ignition cable and spark plug connector are firmly in place. If there is a loose
connection this can result is sparks which could ignite any escaping fuel/air mixture – fire hazard!
If anything is not as it should be, signs of damage are evident, settings are incorrect or the functional
integrity of the unit is compromised, do not start up the power tool. Instead, have it checked by a
specialist workshop.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 644 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 644 in the language / languages: English as an attachment in your email.

The manual is 1,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info