730381

Solis SOLIS Citrus Press Station 8454 Manual

35
Zoom out
Zoom in
Previous page
1/47
Next page
GB GB
6968
OPERATION
1. Check if the Solis Citrus Press Station has been assembled correctly in the
described way.
2. Cut the citrus fruit in two halves. To squeeze juice more effectively, you should
cut the fruit laterally, not lengthwise from end to end.
Note: Some citrus fruits, e.g. mandarines, might have thicker ends. To ensure
optimal contact to the juicing cone, it is recommended to clip the pointed ends
with a knife.
3. Plug the power plug into a suitable wall outlet. Switch the appliance on with
the ON/OFF switch (position I), the orange function light in the switch lights up.
Now, place a glass or another container under the juice spout.
4. Place one half of the citrus fruit, with the cut side facing down, on the juicing
cone and press the fruit onto the spike of the juicing cone.
Caution: If you apply too much pressure, you engage the automatic activation
and the juicing cone starts rotating!
5. Take the lever handle of the press arm and push the lever press arm down slowly
in one smooth movement, until the squeezing cone comes into contact with the
fruit skin. Once this contact is made and some pressure is applied, the motor will
start automatically and the juicing cone will begin spinning. The juice is squeezed
from the fruit and runs through the juice spout into the glass resp. the container.
The pulp and the pips are collected in the pulp filter.
6. As the Solis Citrus Press Station works very effectively, it will only take a few
seconds until one fruit half is juiced. After a short time, you can return the lever
press arm into the highest position and the motor will stop automatically.
7. Take the squeezed-out fruit half from the juicing cone and, if necessary, empty
out the pulp filter resp. repeat steps 4 to 6 to juice the other fruit halves.
Caution:
Do not apply too high pressure to the press arm, the pressure should not exceed
3 kg. Press for a maximum of 15 seconds and then stop applying pressure for
15 seconds.
If the appliance has been in use for 10 minutes, you should take a break of
10 minutes in any case.
Notes:
Thanks to the two different pulp filters, you can choose between having less or
more pulp in your juice.
More pulp: Select the pulp filter with the large holes (J).
Less pulp: Select the pulp filter with the small holes (E).
The pulp filter should be emptied once it is filled with pulp and pips.
If you want to empty the pulp filter while juicing, switch the appliance off with
the ON/OFF switch, pull the power plug, set the lever press arm to the highest
position and carefully remove the juicing cone and the pulp filter. Empty and
rinse the filter and the juicing cone and reinstall both parts in the appliance
before plugging it back in and switching it on to continue juicing.
The pulp filter should never be too full, as this hinders the appliance from func-
tioning optimally resp. might cause damage to it.
Should the diameter of the fruit you wish to juice seem too large or too small
for the pressing cone, the fruit can still be placed on the juicing cone and be
pressed onto the juicing cone by hand to start the juicing rotation. The lever
press arm can remain in its folded-up position. Like this, practically all citrus
fruits can be juiced.
DISASSEMBLING THE APPLIANCE
1. Always switch the appliance off with the ON/OFF switch (position 0) first and
disconnect the power plug from the power socket.
2. Push the lever press arm up, away from the motor base, until it reaches the
highest position. Close the juice spout by folding it up into the no-drip position.
3. Hold the lever press arm and remove the pressing cone and, if mounted, the
dust cover by turning the pressing cone out of the lever press arm in a clockwise
motion and taking it off.
4. Carefully lift the juice collection tray with the pulp filter and the juicing cone.
Remove the juicing cone and the pulp filter from the juice collection tray over a
sink so that the pulp leftovers can be easily removed.
5. Take the drip tray out of the appliance.
6. Clean the single parts as described in the “Cleaning and Care” section on page
71.
Note: Should a little bit of juice drip onto the work surface, please always wipe it
off immediately to prevent the surface from being damaged.
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solis SOLIS Citrus Press Station 8454 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solis SOLIS Citrus Press Station 8454 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info