Manual Solis 1010 - Primaroma (page 43 of 56) (English, German, French, Italian)

663496

Zoom out

Zoom in

1/56

8584

14. To rinse out the machine as well and to remove all descaler residues, please

repeat steps 5 to 10 until only a small amount of water remains in the water

tank. The dwelling time of 15 minutes as mentioned in step 11 does not have

to be kept.

15. Remove the water tank again, empty it and reﬁll it with fresh tap water.

16. Remove the portaﬁlter from the brewing group and rinse it under running water,

after that, dry it.

NOTE: Please wipe potential splashes of descaling solution on the appliance casing

away immediately, as the agent might damage the surface.

WARNING: Never submerge power cord, power plug or the appliance itself

in water or any other liquid. During descaling, never remove the water tank

or allow it to empty completely.

s

DESCALING

Prolonged use or hard water can cause limestone deposits to form in and on many

functioning parts of your machine and reduce operating performance – which, in

turn, reduces the quality of the espresso.

This is why Solis recommends regularly (depending on water hardness but at least

once a month) descaling your Primaroma with a mixture of SOLIPOL

special and

water. Please use only SOLIPOL

special (Art.-No. 703.02) for descaling the ma-

chine. Damages caused by the use of improper descaling agent are not covered by

warranty.

Proceed as follows:

1. Insert the portaﬁlter (without ground coffee) into the brewing head. Pour a

mixture of SOLIPOL

special and water in a ratio of 1:1 into the water tank and

ﬁll it to the MAX marking.

2. Connect the power plug to the socket.

3. Press the ON / OFF button so that the red function light illuminates and the ap-

pliance is switched on.

4. Place a large tank under the brewing head resp. the portaﬁlter and an empty

milk jug under the steam wand.

5. The function button should not be pushed in but be in the brewing position

instead. The selector is set to the standby position in the center l.

6. Wait for the green temperature control light to illuminate. Turn the selector

to the left to the cup position and let approx. 2 cups of water run through.

7. Then return the selector to the standby position in the center l.

8. Push in the function button to set the appliance to steam mode and wait for the

green temperature control light to illuminate.

9. Then, turn the selector to the right to the steam position and let steam

escape from the steam wand into the prepared, empty milk jug (or directly into

the drip tray) for approx. 2 minutes.

10. Then, return the selector to the steam position in the center l. Press the function

button again to set the appliance back to brewing mode.

11. Press the ON / OFF button for at least 3 seconds to switch the appliance off. Let

the descaling solution sit for 15 minutes.

12. Switch the appliance back on after 15 minutes and repeat steps 5 to 11 at least

3 times until the descaling solution is almost used up.

13. When the descaling solution is almost used up, remove the water tank and

carefully rinse it with fresh water to ﬂush out all the descaler residues, then reﬁll

it with fresh tap water.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Solis 1010 - Primaroma in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 2,43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Solis 1010 - Primaroma

Solis 1010 - Primaroma User Manual - English, German, Dutch, French, Italian - 57 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Solis 1010 - Primaroma Manual

Product: