718588

Solac CPB6100 Manual

10
Zoom out
Zoom in
Previous page
1/64
Next page
EN
• If you have hard water ,it is advisable to use
only distilled or demineralized water.
• Do not use chemically delimed water or
perfumed
STEAM IRONING
• 1.Fill the iron as described in the section “how

• 2. Plug the iron into the mains.
• 3.Steam ironing is possible only when hea-
ting is complete.Otherwise ,water may escape
through the soleplate.
•         
prove that the bottom plate has been heated.
• 5.Press Steam switch to realize Steam ironing.
Fig. 4
• 
upright position or on the base when the iron
is interrupted
• 7.Disconnect the iron from the mains supply.
Pour of any remaining water and leave the iron
to cool off.
CONTINUOUS STEAM
• Heating completed, temperature stabilized
• 2.Start steam switch, can choose large steam
or ECO steam at the same time, the two stalls
can be switched at any time. Fig. 5
SHOT OF STEAM
• When the heating is completed, the tempe-
rature is stable.
• Press the steam in two seconds quickly, and
the steam will start to explode in two seconds,

SELF CLEANING
• 1.Please make sure there is enough
water in the tank before cleaning
• 2.Please put the iron in a safe position before
cleaning to prevent people from being injured
by hot water during cleaning
• 3.After the heating is complete , the long press
the cleaning switch for 3 seconds , and the iron
enters the cleaning mode .The display on the

bees. Fig. 7
• 4.Two minutes later, the buzzer rang three
times, indicating that the cleaning was
complete.
AUTO SHUT OFF
• When the iron is stationary for more than 7
minutes, the iron goes out of power mode
• -
companied by six buzzing sounds
• Press the steam switch to restore the power
• Irons will not be cut off during steam discharge
• If you need stop the process switch off the
item
ANTI DRIP
• This iron is equipped with a drip stop function:
the iron automatically stops steaming when
the temperature is too low to prevent water
from dripping out of the soleplate.
ANHYDROUS DETECTION (NO WA-
TER DETECTION)
• In the course of working, if there is no water
in the water tank, the pump will automatically
stop working to protect the life of the pump
DEFECTS AND REPAIRS
• Do not attempt to replace a defective mains
lead .The appliance has to be returned to an
authorized service centre for repair.
CORD STORAGE
• Follow Fig. 8
FAULTSREASONS AND SOLUTIONS
IRON EMITS AN ODOR OR SMOKE
• Iron gives off an odor when turned on for the

to be burnt off allow ten minutes for odor to
disappear.
IRON DOES NOT HEAT
• 
Whether the power switch is turned on
IRON DOES NOT STEAM
• The water tank many be empty. Turn off the
steam regulator and add water. Allow the iron
to heat, and then set the turn on to the steam
setting.
IRON IS LEAKING
• The temperature setting is too low to produce
steam. Shot of steam used too much, allow
iron to re-heat.
ANOMALIES AND REPAIR
• Take the appliance to an authorised technical
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solac CPB6100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solac CPB6100 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info