Manual Sogo SS-18460 (page 14 of 52) (English, German, French, Italian, Portuguese, Spanish)

798898

Zoom out

Zoom in

1/52

ASSEMBLY INSTRUCTIONS

The heater is packaged with the feet

unattached. You must attach them before

operating the heater.

WARNING: Do not operate without feet

attached. Do operate the heater only

in upright position (feet on the bottom,

controls on the top), any other position

could create a hazardous situation.

1. Place the radiator body upside-down on a

scratch-free location, make sure it is stable

and will not fall.

2. Screw off the wing nuts from the U-shaped

bolt provided, attach the U-shaped bolt to the

(near the front cover).

3. To attach the castor mounting plate to the

radiator body, you should insert the threaded

ends of the U bolt in the holes on the castor

mounting plate.

4. Screw the wing nuts back to the U bolt and

fasten the wing nut properly.

Note: do not over tighten, which may cause

5. Repeat 2, 3 and 4 on the rear of radiator for

mounting of the rear castors.

Note: the rear castors must be mounted

INSTRUCTIONS FOR USE

1. Before using the heater, make sure that it is on

it is placed on an incline or decline.

2. Set all the controls to OFF position and

insert the plug into a socket-outlet with well

3. Rotate the thermostat knob clockwise to MAX

position and switch the heater to low, medium

and high

4. When your room reaches the desired

temperature, now slowly rotate the thermostat

knob counter clockwise until the pilot light

goes out. The thermostat can now be left at

this setting. As soon as the room temperature

has dropped below the set temperature, the

unit will switch it self on automatically until

the set temperature has been reached again.

In this way the room temperature remains

constant with the most economical use of

electricity.

5. If you want to change the room temperature

setting, rotate the thermostat knob clockwise

to raise the temperature, or counter clockwise

to lower it.

6. This heater includes an overheat protection

system that shuts off the heater when parts of

the heater are getting excessively hot.

7. To completely shut the heater off, turn all the

controls to OFF, and remove plug from the

socket-outlet.

14 español english français portuguese italiano deutsch

Remark: Only for model SS-18455, fit the

front wheels assembly at the bottom of front

panel by two screws(see Fig 5), the other

wheels assembly same as point 2, 3 and 4.

Tip-over protection

This heater is protected with a safety switch

that turns off the appliance automatically

when the heater falls over, or is at an

excessive angle from the horizontal. This

helps prevent accidents, and the heater will

resume operation when it is put back upright.

Overheat protection

This heater is protected with overheat

protection that switches off the appliance

automatically in case of severe overheating.

In this case, unplug the appliance, wait

about 30 minutes for it to cool and remove

any possible cause of overheating, eg.

something covering the heater. Check for

damage to the appliance, the cord and the

plug. If there is no damage, plug the unit

back in and switch it on as described above.

If the heater still does not turn on, please

contact Customer Service for assistance.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sogo SS-18460 in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1.89 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sogo SS-18460 Manual

Product: