798120
10
Zoom out
Zoom in
Previous page
1/24
Next page
10 español english français portuguese
OPERATING YOUR CHOCOLATE
FOUNTAIN
•
Note: Before using your Chocolate Fountain for the
rsttime,checkallpackaging has beenremoved,
then clean the unit following the instructions under
CARE AND CLEANING.
•
PlacetheChocolateFountainonaatdryandlevel
surface, so the Chocolate Fountain sits evenly on
the bench or table’s surface.
•
The Chocolate Fountain must be level to operate
correctly.
1. Ensure the control switch is set to the OFF position
2. Plug the chocolate fountain into a 230-240V AC
outlet and switch the power on
3. Turn the control switch to “Heat” position. This will
warm the body of the chocolate fountain, ready for
the melted chocolate. The chocolate fountain can
only be operated with pre-melted chocolate
4. Melt chocolate, following direction under Melting
Chocolate
5. Pour the melted chocolate mixture into the base of
the fountain and turn the control switch to Heat /
Motor to start the motor and turn the auger pump,
allowing the chocolate to be drawn up the tower and
lteroutthetopandoverthesidesofthefountain.
6. Let the chocolate fountain operate for a minimum of
5 minutes, then check the consistency. Add extra oil
if required.
•
NOTE: If the chocolate Fountain is not operating as
expected, check the Troubleshooting section later
in this booklet.
MELTING CHOCOLATE
•
Chocolate can vary in quality; therefore the
suggested quantity of all may need to be adjusted
to make the chocolate ow consistently. We
recommended the use of good quality chocolate
melts, the higher the cocoa content the better. Dark
chocolate works best. The amount of oil used can
vary between 125ml to 250ml depending on the
type of chocolate used.
•
Suggested measurements: Combine 1kg of
chocolate melts with ¾ cup of canola oil. The
quickest method to melt the chocolate is in the
microwave, however you need to ensure the
microwave does not get too hot and burn the
chocolate, if your microwave does not have a
medium heat setting or temperature control, we
recommended the stove top melting method. Allow
for extra chocolate top ups if preparing the fountain
for use by lots of people.
•
Microwave melting method Combine 1kg of
chocolate melts with ¾ cup of canola oil in
microwave proof bowl. Heat on medium/low heat
setting for 3 minutes. Remove the mixture from
the microwave, stir, and then heat for a further 1
minute. Repeat this process until the chocolate has
completely melted and is smooth and consistent.
Test the consistency using a large spoon to check
whether the mixture drips evenly from the spoon. If
the mixture is too thick add extra oil.
•
Stove top melting method Combine 1kg of
chocolate melts with ¾ cup of canola oil in a heat
proof bowl. Place the bowl above a saucepan of
simmering water. The hot water should not contact
the base of the bowl. Stir the chocolate mixture until
completely melted, smooth and consistent. Test the
consistency using a large spoon to check whether
the mixture drips evenly from the spoon. If the
mixture is too thick add extra oil.
CARE AND CLEANING
- Ensure the chocolate fountain control switch is set
to the OFF position, turn the power off at the outlet
and unplug the unit from the power supply.
- When the unit has cooled enough to touch, lift
the chocolate from the tower and plastic auger by
letting it drip into the base.
- Wash the tower and auger attachments in warm
soapy water. Avoid placing parts in the dishwasher.
- Do not dispose of leftover chocolate down the
drain. Pour left over chocolate from the base of the
fountain into plastic bag or dispose container then
place in the rubbish.
- Pour as much chocolate out of the base of the
fountain as possible. Wipe the base clean using
a damp, non-abrasive cloth. Wipe dry with paper
towel or soft cloth.
- Do not immerse the base of the chocolate fountain
in water or any other liquid.
- Do not use abrasive cleaning products or cloths on
any part of your Chocolate Fountain.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sogo SS-11945 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sogo SS-11945 in the language / languages: English, French, Portuguese, Spanish as an attachment in your email.

The manual is 0.53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info