662824
4
Zoom out
Zoom in
Previous page
1/34
Next page
4
A. Operating elements
1. Minus ( )
2. Confirm (
)
3. Plus (
)
Sensor Touch: Touch
keys only slightly!
B. Preparation
1. Remove battery strip.
Note: Immediately (as long as „0.0“ is still
being displayed) place the body analysis scale
on a level surface and wait until the scale
powers down automatically.
Then begin data input. Otherwise, it might be
possible that the weight of the scale would
erroneously be added to the initial weighting
process.
The same might occur during regular operati-
on if the scale is held in the hand prior to the
weighting process.
2. For all measurements, place scale level on a
hard surface (not carpet).
3. Cleaning and Care: clean only using slightly
damp cloth. Do not use solvents or abrasives.
Never submerge scale in water.
4. A country-specific option to switch from kg/cm
to lb/in or st/in is possible by pushing the key
on the bottom of the scale to switch units.
Attention! Slipping hazard
in case of wet surface.
C. Data input
1. Push key.
2. Use
/ keys to select memory slot and con-
firm (
).
3. Then use
/ keys enter body height.
Use to confirm.
4. In the next step enter the age and confirm.
5. Finally select sex and confirm.
6. Now immediately place the body analysis
scale on the floor, wait until the screen dis-
plays „0.0“ and then step on the scale with
bare feet.
The initial measurement is indispensable and
serves to store the data for later automatic
recognition of persons. If no person steps on
the scale, data input must be repeated.
The first body analysis is performed after a
person steps on the scale.
This scale is equipped with a Time-Out mode.
It will automatically switch off after approx.
40 seconds if no keys are pressed.
Data must be entered again after battery
change.
D. Body analysis
1. Place scale on hard, level surface and wait
until the scale switches off automatically.
2. Step barefoot onto scale. Please stand still.
3. The body weight will be displayed.
The scale determines the body values (body
fat, body water, muscle mass, kcal).
Note: Body values are calculated based on the
determined weight and the personal data.
The scale shuts off auto matically.
E. Notifications
1. Replace batteries
2. Overload: max. 180 kg
3. The measured value is higher (H) or lower (L)
than the limit.
10 - 60 % 5 -90 % 5 -90 %
4 - 60 % 5 -90 % 5 -90 %
F. Technical data
Max. 180 kg/100 g
Max. 396 lb/0.2 lb
Max. 28 st/0.2 lb
Batteriy requirement: 1 x 3V CR 2430
EN
63858-BA-PWD-Modell-R-13199-A-Content-10-08-2016.indd 4 12.08.2016 13:03:58
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soehnle 63858 - Shape Sense Control 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soehnle 63858 - Shape Sense Control 200 in the language / languages: All languages as an attachment in your email.

The manual is 3,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info