809893
9
Zoom out
Zoom in
Previous page
1/30
Next page
9
snom PA1+ User Manual Setting Up
2. Drill the holes and insert the expansion anchors in the holes.
3. Place the Snom PA1+ on the wall with the cut-outs above the anchors as shown in Fig. 2.
Fig. 2
4. Place the screws in the anchors and tighten them evenly..
Connecting the PA1+
Low impedance connection (ex. 4–32 Ohm)
Fig. 1 Fig 2
1. Plug the Ethernet cable into the RJ45 connector labelled "Port 1PoE", as shown in Fig. 1. The
second RJ45 connector labelled "Port 2" is for daisy-chaining further Ethernet devices without the
need for another Ethernet cable.
If no PoE available: Connect a Snom-approved 5V 10W power supply to the power
connector labelled "5V DC".
2. Connect the loudspeaker wires to the speaker terminals labelled "Speaker", as shown in Fig. 2.
Connect the "+" wire with the red terminal, connect the "-" wire with the black terminal.
Note: If you want to use a headset during the setup:
Connect the headset's microphone plug to the jack labelled "Mic-In".
Connect the headset's speaker plug to the jack labelled "Line Out".
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Snom PA1 plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Snom PA1 plus in the language / languages: English as an attachment in your email.

The manual is 1.17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info