After unpacking the hob, check that there has been no damage during transport. If in doubt, contact the dealer or After-sales Service.
PREPARING THE HOUSING UNIT
Connecting to the terminal board
The hob is provided with a pentapolar cable 5x2.5 mm
2
, suitable for the connection 400 V 3N ~. For electrical connection, use the cable supplied or an H05RR-F cable
as specified in the table below.
Connect the yellow/green earth wire to the terminal with the symbol .
This wire must be longer than the other wires.
1.Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).
2.Insert the power supply cable into the cable clamp and connect the wires to the terminal board as indicated in the diagram next to the terminal board itself.
3.Secure the power cable with the cable clamp.
4.Close the cover (C) and screw it on the terminal block with the removed screw - point (1).
Each time the cooktop is connected to the mains it carries out an automatic check which lasts several seconds.
If the hob already has a power cable, follow the instructions given on the label attached to the cable. Connect the appliance to the electricity supply by means of an all-
pole disconnect switch with minimum contact gap of 3 mm.
INSTALLATION
WARNING
-Install a separator panel under
the hob.
-The lower part of the product
must not be accessible after
installation.
-If there is an oven beneath the
hob, do not install the separator
panel.
•For the distance between the underside of the appliance and the separator panel below, observe the dimensions given in the figure.
•In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).
•Cut the worktop to fit before installing the hob and carefully remove any shavings or sawdust.
•If an oven is installed beneath the hob, make sure that it is equipped with a cooling system.
•To remove the hob from the worktop use a screw driver (not supplied) unlocking the springs from the bottom side of the appliance.
•Do not install the hob above a dishwasher or washing machine, to prevent the electronic circuits from coming into contact with steam or moisture and being
damaged as a result.
ELECTRICAL CONNECTION
WARNING
-Disconnect the appliance from the mains power supply.
-The appliance must be installed by a qualified technician who is fully aware of current safety and
installation regulations.
-The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the
regulations provided in this chapter.
-The power supply cable must be long enough to allow the hob to be removed from the worktop.
-Make sure the voltage specified on the appliance rating plate is the same as that of the domestic power supply voltage.
-Do not use extension cables.
ConductorsAmount x size
220-240 V ~ +
3 x 4 mm
2
220-240 V 3 ~ +
4 X 1.5 mm
2
380-415 V 3N ~ +
5 X 1.5 mm
2
380-415 V 2N ~ +
4 X 1.5 mm
2
min 5 mm
min 20 mm
min 5 mm
380-415 V 3N ~220-240 V ~220-240 V ~ (UK - AU)
380-415 V 2N ~220-240 V 3 ~ (Belgium only)380-415 V 2N ~ (NL only)
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Smeg SIM581B at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Smeg SIM581B in the language / languages: English as an attachment in your email.
The manual is 3,51 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
