72820
19
Zoom out
Zoom in
Previous page
1/20
Next page
Instructions for the Installer
61
14.INSTALLING THE APPLIANCE
The appliance must be installed by a qualified engineer in compliance with the relevant regulations. It
may be installed against walls one of which is higher than the worktop surface, as shown in the
installation class drawings A and B. Wall units or extractor hoods installed above the appliance's work-
top must be at least 75 cm above it.
A) B)
14.1 Electrical connection
Check that the voltage and size of the power supply line are as specified on the nameplate inside the
storage compartment. This nameplate must never be removed.
If a permanent connection to the electrical mains is used, the appliance's power supply line must be
fitted with an omnipolar breaking device with contact breaking gap of at least 3 mm located in an easily
accessible position close to the appliance itself.
The mains connection may be permanent or by means of a plug and socket. If a plug and socket
connection is used, suitable cable compliant with the relevant standards must be used. For each type of
connection, the appliance must always be connected to earth. Before connecting it, check that the power
supply line is properly earthed. The use of adapters is not recommended since they may cause
overheating.
The appliance has a terminal board on its rear. Make the
electrical connection in accordance with the wiring diagram
shown below.
To access the terminal board, remove the guard on the rear.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Smeg SCB 64 MPX 6 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Smeg SCB 64 MPX 6 in the language / languages: English as an attachment in your email.

The manual is 1,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Smeg SCB 64 MPX 6

Smeg SCB 64 MPX 6 User Manual - German - 20 pages

Smeg SCB 64 MPX 6 User Manual - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info