Manual Smeg FC 35 APS (page 9 of 13) (English)

77661

Zoom out

Zoom in

1/13

6565

of the appliance body and any furniture that

may be above it (ﬁg. 5). If this requirement

is not followed, the appliance consumes more

electrical energy and its compressor may

overheat.

• If the appliance is placed in a corner, a

gap of at least 1 cm must be left between the

appliance body and the wall so that the freezer

compartment door can be opened enough to

pull out the frozen product drawer (ﬁg. 6).

• The appliance must stand on a level surface

and must not touch the wall. If necessary,

regulate the height of the appliance by adjusting

the levelling feet 25 (ﬁg. 1): by turning them

clockwise – the front of the appliance rises,

by turning them counter clockwise – it comes

down. If the appliance is tilted slightly backward

– the doors will close by themselves.

CONNECTION TO THE MAINS

WARNING! The appliance must be

plugged in to an earthed electricity supply

socket.

• The frequency and power of the electricity

supply in your house must conform to the

general data parameters of the appliance as it

is shown in the table (see page 63).

• When positioning the appliance, be careful

that the electrical cord isn’t squeezed in order

to avoid its damage. This can cause a short

circuit and a ﬁre.

• Make sure that the plug of the electrical

cord is not squeezed by the back wall of the

appliance or otherwise damaged. A damaged

plug can be the cause of a ﬁre!

• When unplugging the appliance, do not

touch the plug pins of the electrical cord.

CHANGING THE INTERIOR LIGHT

BULB

When changing the interior light bulb (ﬁg. 7),

do the actions below in the order they are

listed:

1. Unplug the appliance from the mains by

pulling the plug out of the electricity supply

socket.

2. Squeeze the sides of the light ﬁxture cover

1 to unhook the cover fasteners A and pull

downward. Remove the cover.

3. Replace the light bulb with the same 15 W

type light bulb with the E14 lamp holder.

4. After changing the light bulb, put the cover

fastener hook in place B and then press upward

until its ﬁxing in place.

5. Plug the appliance into the electricity supply

socket.

CHANGING THE OPENING

DIRECTION OF THE DOORS

It is recommended that changing the opening

direction of the doors should be done with a

helper. You will need two spanners No. 8 and

No. 10 and a Philips head screwdriver.

! When changing the opening direction of

the doors, YOU CAN NOT lay the refrigerator

horizontally. Do the actions below in the order

they are listed (ﬁg. 8):

WARNING! Turn off the appliance and

pull the plug out of the electricity supply

socket.

1. Remove the covers c from the body of the

refrigerator and of the inner side of the door.

Also remove the upper bracket 6 together with

the nut and washers and the spacer under the

bracket.

2. Remove the door of the refrigeration

compartment. Remove the stopper 5 from the

bottom of it. On the other side of the door,

attach the stopper intended for doors that open

on the left (you will ﬁnd it in the packet).

3. Remove the middle bracket 4 together

with the washers on the axle and the plastic

spacer.

4. Remove the freezer compartment door 3.

5. Remove the bottom cover 1.

6. Remove the bottom bracket 2 together with

the washers on the axle and the plastic spacer.

Unscrew the axle with the washers and

screw it into the aperture provided on the other

side.

7. Remove the bottom bracket 7 and in its place

attach the other bottom bracket 2 together with

the washers on the axle and the plastic spacer.

Fix this bracket 7 in place of the other bracket 2.

8. Remove the covers 8 from the partition

separating the refrigeration compartment from

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Smeg FC 35 APS in the language / languages: English as an attachment in your email.

The manual is 0,37 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Smeg FC 35 APS

Smeg FC 35 APS User Manual - German - 13 pages

Smeg FC 35 APS User Manual - Dutch - 13 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Smeg FC 35 APS Manual

Product: