346741
9
Zoom out
Zoom in
Previous page
1/13
Next page
6565
GB
of the appliance body and any furniture that
may be above it (fig. 5). If this requirement
is not followed, the appliance consumes more
electrical energy and its compressor may
overheat.
If the appliance is placed in a corner, a
gap of at least 1 cm must be left between the
appliance body and the wall so that the freezer
compartment door can be opened enough to
pull out the frozen product drawer (fig. 6).
The appliance must stand on a level surface
and must not touch the wall. If necessary,
regulate the height of the appliance by adjusting
the levelling feet 25 (fig. 1): by turning them
clockwise – the front of the appliance rises,
by turning them counter clockwise – it comes
down. If the appliance is tilted slightly backward
– the doors will close by themselves.
CONNECTION TO THE MAINS
WARNING! The appliance must be
plugged in to an earthed electricity supply
socket.
The frequency and power of the electricity
supply in your house must conform to the
general data parameters of the appliance as it
is shown in the table (see page 63).
When positioning the appliance, be careful
that the electrical cord isn’t squeezed in order
to avoid its damage. This can cause a short
circuit and a fire.
Make sure that the plug of the electrical
cord is not squeezed by the back wall of the
appliance or otherwise damaged. A damaged
plug can be the cause of a fire!
• When unplugging the appliance, do not
touch the plug pins of the electrical cord.
CHANGING THE INTERIOR LIGHT
BULB
When changing the interior light bulb (fig. 7),
do the actions below in the order they are
listed:
1. Unplug the appliance from the mains by
pulling the plug out of the electricity supply
socket.
2. Squeeze the sides of the light fixture cover
1 to unhook the cover fasteners A and pull
downward. Remove the cover.
3. Replace the light bulb with the same 15 W
type light bulb with the E14 lamp holder.
4. After changing the light bulb, put the cover
fastener hook in place B and then press upward
until its fixing in place.
5. Plug the appliance into the electricity supply
socket.
CHANGING THE OPENING
DIRECTION OF THE DOORS
It is recommended that changing the opening
direction of the doors should be done with a
helper. You will need two spanners No. 8 and
No. 10 and a Philips head screwdriver.
! When changing the opening direction of
the doors, YOU CAN NOT lay the refrigerator
horizontally. Do the actions below in the order
they are listed (fig. 8):
WARNING! Turn off the appliance and
pull the plug out of the electricity supply
socket.
1. Remove the covers c from the body of the
refrigerator and of the inner side of the door.
Also remove the upper bracket 6 together with
the nut and washers and the spacer under the
bracket.
2. Remove the door of the refrigeration
compartment. Remove the stopper 5 from the
bottom of it. On the other side of the door,
attach the stopper intended for doors that open
on the left (you will find it in the packet).
3. Remove the middle bracket 4 together
with the washers on the axle and the plastic
spacer.
4. Remove the freezer compartment door 3.
5. Remove the bottom cover 1.
6. Remove the bottom bracket 2 together with
the washers on the axle and the plastic spacer.
Unscrew the axle with the washers and
screw it into the aperture provided on the other
side.
7. Remove the bottom bracket 7 and in its place
attach the other bottom bracket 2 together with
the washers on the axle and the plastic spacer.
Fix this bracket 7 in place of the other bracket 2.
8. Remove the covers 8 from the partition
separating the refrigeration compartment from
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Smeg fc 32 ap aps at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Smeg fc 32 ap aps in the language / languages: English as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Smeg fc 32 ap aps

Smeg fc 32 ap aps User Manual - German - 13 pages

Smeg fc 32 ap aps User Manual - Dutch - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info