658172
26
Zoom out
Zoom in
Previous page
1/33
Next page
4 Maintenance
4 - 3
IDF1E11E
Open the residual pressure release cock at
the drain tube connection port to release air
and drain fluid left in the product.
(Leave the drain tube connected and hold it
with hand so that it does not get twisted.)
Because drain may be given by air
pressure left in a product like a careful.
Remove the drain tube.
Pull out the tube while pushing up the drain
tube release bush.
Hold the case assembly lightly and pull down
the lock button with thumb. Then, turn the
case assembly to the left (or right) to 45°to
align the marks.
Release your thumb from the lock button and
slowly pull down the case assembly
(vertically) to remove it.
Remove the auto drain strainer and clean it. Take care
not to cut your hand with the sharp edges of the
strainer.
Pour solution of neutral detergent into the case
assembly and shake it well to clean.
Check the case O-ring for damage such as scratches,
twisting or foreign particles attached to it. Then, apply
grease thinly and fit it in the groove in the case
assembly.
Fit the auto drain strainer to the case assembly and fit
it into the drain separator body. Turn it untill the lock
button clicks.
Try to turn the case assembly lightly and check that it
does not turn. If it turns, start with fitting the case
assembly to the body again.
Close the residual pressure release cock and mount
the drain tube and front panel as they were.
When reapplying compressed air to the air dryer, first
open the valve on the inlet side slowly. Check for
compressed air leak and if everything is all right, open
the valve on the outlet side.
If the auto drain strainer or case assembly is
damaged or very dirty, replace it with a new one.
SO
Drain tube
O
p
en
Drain tube
rerease bush
Close
Lock button
Residual
pressure
rerease cock
Pull it down
slowly.
Mark
Lock button
Turn to 45
(right or left)
Drain separator
body
Auto drain
strainer
“O”ring
Case assembly
CAUTION
Check that air
pressure is zero
before servicing.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SMC IDF15E-20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SMC IDF15E-20 in the language / languages: English as an attachment in your email.

The manual is 0,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info