658170
27
Zoom out
Zoom in
Previous page
1/33
Next page
4 Maintenance
4 - 4
IDF15E
O
pen the residual pressure release cock at the drain
tube connection port to release air and drain fluid left
in the product.
(Leave the drain tube connected and hold it with hand
so that it does not get twisted.)
Remove the tube while pushing the release bush.
Hold the case assembly lightly and pull down the lock button
with thumb.Then, turn the case assembly to the left (or right)
to 45°to align the marks,Release your thumb from the lock
button and slowly pull down the case assembly (vertically)
to remove it.
Remove the auto drain strainer and clean it. Take care not
to cut your hand with the sharp edges of the strainer.
Pour solution of neutral detergent into the case assembly
and shake it well to clean.
Check the case O-ring for damage such as scratches,
twisting or foreign particles attached to it. Then, apply
grease thinly and fit it in the groove in the case assembly.
Fit the auto drain strainer to the case assembly and fit it into
the drain separator body. Turn it untill the lock button clicks.
Try to turn the case assembly lightly and check that it does
not turn. If it turns, start with fitting the case assembly to the
body again.
Close the residual pressure release cock and mount the
drain tube and front panel as they were.
If the auto drain strainer or case assembly is damaged or
very dirty, replace it with a new one.
Drain tube
Open
Close
Residual pressure
release cock
Drain tube
release bush
Lock button
Lock button
Mark
To remove the case assembly, turn it to
45
°until the lock button and mark align.
Then, pull it down slowly.
S
O
Auto drain strainer
"O"ring
Lock button
Case assembly
Residual pressure
release cock
Release bush
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SMC IDF11E-20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SMC IDF11E-20 in the language / languages: English as an attachment in your email.

The manual is 0,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info