566138
181
Zoom out
Zoom in
Previous page
1/228
Next page
X
Insert a suitable object such as a coin
into the slot at the eyelet of the key
housing.
X
Carefully turn the coin until key housing
top half : is unlatched.
X
Open key housing top half : to the side.
X
Remove transmitter battery ; from the
board.
!
Check the polarity when inserting the
new transmitter battery. You could
otherwise damage parts of the electrical
system. When inserting the batteries,
make sure they are clean and free of lint.
X
Insert the new transmitter battery.
X
Press both halves of the key housing
together again.
X
Check the operation of the remote
control.
Replacing bulbs
About replacing bulbs
Safe vehicle operation depends on proper
exterior lighting and signaling. It is
therefore essential that all bulbs and lamp
assemblies are in good working order at all
times.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. Contact an
authorized smart center for headlamp
adjustment.
G
WARNING
Bulbs and bulb sockets can be very hot.
Allow the lamp to cool down before changing
a bulb. Otherwise you could be burned if you
touch them.
Keep bulbs out of the reach of children.
Halogen lamps contain pressurized gas. A
bulb can explode if you:
R
touch or move it when hot
R
drop the bulb
R
scratch the bulb
Wear eye and hand protection.
i
If the headlamps or front fog lamps* are
fogged up on the inside as a result of
high humidity, driving the vehicle a
distance with the lights on should clear
up the fogging.
Notes on bulb replacement:
R
Only use bulbs of the same type and with
the specified watt rating.
R
Switch the lights off before replacing a
bulb to prevent short circuits.
R
Always use aclean lint-free cloth when
handling bulbs.
R
Your hands should be dry and free of oil
and grease.
R
Avoid touching the glass of the bulb with
bare fingers.
R
If the newly installed bulb does not come
on, contact an authorized smart center.
R
Have the bulbs for the front fog lamps*
and the LED daytime running lamps*
replaced at an authorized smart center.
178
Replacing bulbs
>> Practical hints.
* optional
181


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Smart for two 2013 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Smart for two 2013 in the language / languages: English as an attachment in your email.

The manual is 7,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info