490932

Skytec 6 channel mixer Manual

5
Zoom out
Zoom in
Previous page
1/30
Next page
The RCA inputs are for connection of a CD player or a turntable. You can now route the signal via the
“tape/rec to control room level” push button (17) to the studio monitors or to the master routes via the
push button “tape / rec to master” (18). Make sure however that the push button (17) is in the up
position otherwise the signal will be input twice.
Connect the mixer to an amplifier via the balanced “stereo out” sockets (22). Use 2 6.3mm mono jacks
for this connection. The total output volume is set via the master volume button (19).
The mixer is fitted with a separate headphone output (23). The signal is the same as from the control
room output (27). The volume control (16) sends the signal to the headphones and the monitors. The
L/R meters are the same as the master output
INSTALLATION
Do not mix up the cable in order to avoid wrong connections. Connect the leads one by one and not all
leads on one side first and then all on the other side. In the worst case, you might permanently
damage the unit. Figure 2 shows an example of possible connections.
Prior to connecting the mixer, set all controls to “0”. You can connect microphone or line units to the
mono channels, all kinds of line units to the stereo channels and effect units to the AUX Return. You
can also connect Midi instruments to the AUX Return.
If you connect a microphone, make sure that the phantom power is switched OFF. DO NOT use
unbalanced units when the phantom power is switched on. Do not short-circuit the 48V circuit of the
phantom power to the ground. You might heavily damage the unit.
FIGUUR 2
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Skytec 6 channel mixer at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Skytec 6 channel mixer in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info