GB
General functions
Turning on and off
By pressing the button you switch the
radio on and off. When switched on, the
appliance assumes the parameters last
heard for treble, bass, balance etc. Only the
radio volume may be reduced to the
maximum volume in the set-up menu when
the radio is turned on.
Volume control
When on, the on/off button sticks out of
the front, which makes it possible to set the
volume.
Turn the button to the right or left to set
the required volume.
Setting the sound
You can set the sound tone of the radio to
suit your requirements. Please note that
the radio receiver, CD player, CD changer,
TIM playback and telephone allow sepa-
rate settings and storing.
Proceed as follows:
Bass setting:
• Press the AUD button
. The indication
BASS appears in the display with the
current scale value.
• Use the control
to set the required
bass setting from -9 to +9.
• Treble setting:
• Press the AUD button
(if you wish to
select treble regulation from normal op-
eration, press button
twice to go to the
treble setting. The indication TRE
appears in the display with the current
scale value.
• Use the control
to set the required
treble setting from -9 to +9.
5 seconds after the last setting or when
the button
is pressed again, the car
radio switches back to normal operation
and stores the set values.
Geometry (balance and fader)
You can set the geometry of the sound tone
to suit your requirements.
Proceed as follows:
Balance:
• Press the GEO button .
The indication BAL appears in the display
with the current scale value.
• Use the control to set the required
balance setting from LEFT 9 via CENTER
to RIGHT 9.
Fader:
• By pressing the GEO button again (if
you wish to select fader control from nor-
mal operation, you must press button
twice), you go to fader control. The indica-
tion FAD appears in the display with the
current scale value.
• Use the control to set the required fader
setting from REAR 9 via CENTER to
FRONT 9.
5 seconds after the last setting or when
the button
is pressed again
, the car
radio switches over automatically to normal
operation and stores the set values.
5
