678359
8
Zoom out
Zoom in
Previous page
1/18
Next page
Tyre repair kit* 7
Inflation hose with plug
Compressor
Tyre inflation hose
Tyre inflation pressure indicator
Air release valve
ON and OFF switch
12 volt cable connector
Tyre inflator bottle with sealing agent
Replacement valve core
The valve remover has a slot at its lower end which fits into the valve core. This is
the only way in which you can remove and re-install the valve core from the tyre valve.
The same also applies to the replacement valve core .
Preparing to use the tyre repair kit
Before using the tyre repair kit, carry out the following preparatory work:
Park the vehicle as far away as possible from the traffic flow. Park on as flat and firm
a surface as possible.
–Have all the occupants get out. While changing a wheel, the occupants of the
vehicle should not stand on the road (instead of behind a crash barrier).
Switch off the engine and engage 1st gear or if your vehicle is fitted with an auto-
matic gearbox, position the selector lever into position P.
Apply the handbrake firmly.
Check whether you can carry out the repairs with the tyre repair kit page 6,
“General information”.
If a trailer is coupled, uncouple it.
Remove the tyre repair kit from the luggage compartment.
Stick the sticker page 6, fig. 5 on the dash panel in view of the driver.
Do not remove the foreign body, e.g. screw or nail, from the tyre.
Unscrew the valve cap.
Use the valve remover to remove the valve core and place it down on a clean
surface.
Seal and inflate tyres
Sealing tyres
Forcefully shake the tyre inflator bottle page 6, fig. 5 several times.
Firmly screw inflation hose onto the tyre inflator bottle in a clockwise direction
. The film on the cap is pierced automatically.
Remove the plug from the inflation hose and plug the open end fully into the
tyre valve.
Hold the bottle with the floor facing upwards and fill the whole sealing agent in
the tyre inflator bottle into the tyres.
Remove the empty tyre inflator bottle from the valve.
Screw the valve core back into the tyre valve using the valve remover .
Pumping up the tyres
Screw the tyre inflation hose page 6, fig. 5 of the air compressor firmly onto
the tyre valve.
Check whether the air release valve is closed.
Start the engine and run it in idle.
Plug the cable connector into the 12 Volt socket in the vehicle, see Owner's
manual.
Switch on the air compressor with the ON and OFF switch .
Allow the air compressor to run until reaching a pressure of 2.0 - 2.5 bar. Maximum
run time of 8 minutes !
Switch off the air compressor with the ON and OFF switch.
If you cannot reach an air pressure of 2.0 – 2.5 bar, unscrew the tyre inflation hose
from the tyre valve.
A
3
A
4
A
5
A
6
A
7
A
8
A
9
A
10
A
11
A
1
A
11
A
2
A
1
A
10
A
3
A
10
A
3
A
10
A
1
A
5
A
7
A
9
A
8
A
5
s3lg.1.book Page 7 Monday, September 20, 2010 8:07 AM
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Skoda Superb - 2010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Skoda Superb - 2010 in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Skoda Superb - 2010

Skoda Superb - 2010 User Manual - English - 287 pages

Skoda Superb - 2010 Additional guide - German - 18 pages

Skoda Superb - 2010 User Manual - German - 295 pages

Skoda Superb - 2010 Additional guide - Dutch - 18 pages

Skoda Superb - 2010 User Manual - Dutch - 295 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info