678345
184
Zoom out
Zoom in
Previous page
1/218
Next page
Remove the empty tyre inflator bottle from the valve.
Screw the valve core back into the tyre valve using the valve remover
1
.
Inflating
Screw the tyre inflation hose
5
» Fig. 152 on page 181 of the air compressor
firmly onto the tyre valve.
Check that the air release valve
7
is closed.
Start the engine and run it in idle.
Plug the connector
9
into 12 Volt socket » page 56, 12-volt power outlet.
Switch on the air compressor with the ON and OFF switch
8
.
Allow the air compressor to run until a pressure of 2.0 - 2.5 bar is achieved. Max-
imum run time of 8 minutes »
!
Switch off the air compressor.
If you cannot reach an air pressure of 2.0 – 2.5 bar, unscrew the tyre inflation
hose
5
from the tyre valve.
Drive the vehicle 10 metres forwards or backwards to allow the sealing agent to
“distribute” in the tyre.
Firmly screw the tyre inflation hose
5
back onto the tyre valve and repeat the
inflation process.
If you cannot reach the required tyre inflation pressure here either, this means
the tyre has sustained too much damage. You cannot seal with tyre with the
breakdown kit »
.
Switch off the air compressor.
Remove the tyre inflation hose
5
from the tyre valve.
Once a tyre inflation pressure of 2.0 – 2.5 bar is achieved, continue the journey at
a maximum speed of 80 km/h (50 mph).
Check the tyre inflation pressure after driving for 10 minutes » page 182.
WARNING
The tyre inflation hose and air compressor may get hot as the tyre is being
inflated – there is a risk of injury.
Do not place the hot tyre inflation hose or hot air compressor on flammable
materials – there is a risk of fire.
If you cannot inflate the tyre to at least 2.0 bar, this means the damage sus-
tained was too serious. The sealing agent cannot be used to seal the tyre.
Do not drive the vehicle. Seek help from a specialist garage.
CAUTION
Switch off the air compressor after running 8 minutes at the latest – there is a
risk of overheating. Allow the air compressor to cool a few minutes before switch-
ing it on again.
Check after 10 minutes' driving
First read and observe the introductory information and safety warn-
ings on page 180.
Check the tyre inflation pressure after driving for 10 minutes!
If the tyre pressure is 1.3 bar or less
Do not drive the vehicle! You cannot properly seal with tyre with the break-
down kit.
If the tyre pressure is 1.3 bar or more
Adjust the tyre inflation pressure to the correct value (see inside of fuel filler
cap).
Continue driving carefully to the nearest specialist garage at a maximum speed
of 80 km/h (50 mph).
Jump-starting
Introduction
This chapter contains information on the following subjects:
Jump-starting using the battery from another vehicle
183
Jump-starting in vehicles with the START-STOP system
184
WARNING
A discharged vehicle battery may already freeze at temperatures just below
0 °C. If the battery is frozen, do not jump start with the battery of another ve-
hicle – there is a risk of explosion.
Pay attention to the warning instructions relating to working in the engine
compartment » page 155.
182
Do-it-yourself
184


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Skoda Rapid - 2013 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Skoda Rapid - 2013 in the language / languages: English as an attachment in your email.

The manual is 15,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Skoda Rapid - 2013

Skoda Rapid - 2013 User Manual - German - 223 pages

Skoda Rapid - 2013 User Manual - Dutch - 221 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info