678226
125
Zoom out
Zoom in
Previous page
1/160
Next page
CAUTION
Screw the jack back to its starting position prior to putting it back in its box -
otherwise, there is a risk of damage to the box.
Note
The declaration of conformity is included with the jack or the log folder.
Changing a wheel
Preliminary work
For safety's sake, the following instructions must be observed before
changing a wheel on the road.
As far as possible park the vehicle as far as possible away from the traffic
flow - choose a place with a flat and firm surface.
Switch off the engine.
For vehicles with manual transmission select 1st gear.
For vehicles with automated transmission shift the lever to position D or R.
Firmly apply the handbrake.
Switch on the hazard warning lights and set up the warning triangle at the
prescribed distance.
Have all the occupants get out. The passengers should not stand on the
road while the wheel is being changed (they should remain behind a crash
barrier, for instance).
Changing a wheel
Remove the spare wheel » page 124.
Remove the full wheel trim » page 124 or caps » page 124.
Loosen the wheel bolts » page 125 » .
Jack up the vehicle until the wheel that needs changing, is clear of the
ground » page 125.
Unscrew the wheel bolts and place them on a clean surface (cloth, paper,
etc.).
Remove the wheel carefully.
Attach the spare wheel and slightly screw on the wheel bolts.
Lower the vehicle.
Tighten the wheel bolts opposite each other using the wheel wrench (“pull-
ing crossways”) » page 125.
Replace the wheel trim » page 124 and caps » page 124.
When fitting a wheel with unidirectional tyres, ensure that the direction of ro-
tation is correct » page 118.
All bolts must be clean and must turn easily. If screws are corroded and diffi-
cult to move, these must be replaced.
WARNING
Undo the wheel bolts just a little (about one turn), provided the vehicle
has not yet been jacked up. Otherwise the wheel could come loose and fall
off – risk of injury.
Under no circumstances must the bolts be greased or oiled - cause an ac-
cident.
Subsequent steps
After changing the wheel, the following work must be carried out.
Stow the replaced wheel in the well under the floor covering of the luggage
compartment and secure with a locking screw.
Stow the tool kit in the space provided and secure using the band.
Check tyre pressure on the mounted wheel and adjust if necessary and, with
vehicles with tyre pressure monitoring, save the tyre pressure values in the
system » page 100.
Have the tightening torque of the wheel bolts checked as soon as possible.
The prescribed tightening torque is 110 Nm.
Replace the damaged tyre. Repairing the tyre is not recommended.
WARNING
Tightening torque which is too high can damage the threads and this can
result in permanent deformation of the contact surfaces on the rim. Where
tightening torque is too low, the wheels may become loose while driving -
risk of accident. Therefore drive cautiously and only at a moderate speed
until the tightening torque has been checked.
123
Emergency equipment and self-help
125


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Skoda Citigo - 2017 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Skoda Citigo - 2017 in the language / languages: English as an attachment in your email.

The manual is 25,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Skoda Citigo - 2017

Skoda Citigo - 2017 User Manual - German - 168 pages

Skoda Citigo - 2017 User Manual - Dutch - 168 pages

Skoda Citigo - 2017 User Manual - French - 172 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info