489069

Sitecom WL-404 Manual

9
Zoom out
Zoom in
Previous page
1/64
Next page
2. Basic Setup
System Requirements
• To use the wired LAN interface, a standard 10/100BaseT hub or switch and network
cable is required.
• To use the Wireless interface on the Wireless IP Camera with MPEG4/MJPEG, other
Wireless devices must be compliant with the IEEE802.11b or IEEE802.11g
specifications. All Wireless stations must use compatible settings.
The default Wireless settings are:
Mode
SSID
Security
Channel
Infrastructure
Sitecom
Disabled
Auto
Installation - Network Camera
1. Assemble the Camera
Screw the supplied antenna to the mounting point on the rear.
Attach the Camera Mount to the camera.
2. Connect the LAN Cable
Connect the Network Camera to a 10/100BaseT hub or switch, using a standard LAN
cable.
For the WL-404, plugging in the LAN cable will disable the Wireless
interface. Only 1 interface can be active at any time.
The LAN cable should only be connected or disconnected when the
camera is powered OFF. Attaching or detaching the LAN cable while the
camera is powered on does NOT switch the interface between wired and
wireless.
The first time you connect to the camera, you should connect the LAN
cable and configure the Network Camera with appropriate settings. Then
you can unplug the LAN cable and power off the camera. The Network
Camera will be in wireless interface when you power on the camera
again.
3. Power Up
Connect the supplied 5V power adapter to the Network Camera and power up. Use only
the power adapter provided. Using a different one may cause hardware damage.
4. Check the LEDs
• The Power LED will turn on briefly, then start blinking. It will blink during startup,
which takes 15 to 20 seconds. After startup is completed, the Power LED should
remain ON.
• The Network LED should be ON.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sitecom WL-404 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sitecom WL-404 in the language / languages: English as an attachment in your email.

The manual is 5,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info