616575
11
Zoom out
Zoom in
Previous page
1/47
Next page
5 Stitch Sewing Machine
Changing snap-on presser feet (B), (D), (J),
(L)
Your machine comes with the General Purpose
Presser Foot (B) already attached. You can easily
change to any one of the other presser feet which
snap onto a common shank by following the directions
below.
* Raise needle to its highest position by turning hand
wheel toward you.
* Raise presser foot using presser foot lifter at back of
machine.
* Push toe of presser foot (1) up, until it snaps off the
shank (2).
* Remove foot from machine.
* Place new foot under center of shank.
* Lower presser foot lifter, fitting shank over presser
foot pin (3).
* Don't turn screw. Instead, push presser foot screw
(4) down, firmly until foot snaps into place.
Changing screw-on presser feet (H)
Some special presser feet with built-in shanks can be
purchased at your SINGER dealer and can be
replaced as follows:
* Raise needle and presser foot.
* Loosen presser hot screw (1) and remove presser
foot with shank (2), guiding it toward you and to the
right.
* To replace presser foot with shank, hook shank
around the presser bar and tighten presser foot screw
with the use of a coin.
11
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Singer FM17 5820 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Singer FM17 5820 in the language / languages: English as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info