616477
66
Zoom out
Zoom in
Previous page
1/80
Next page
66
SEWING ON BUTTONS
No. 10
General Purpose Foot
1. Lower the feed dogs by moving the drop feed
lever to the left.
2. Attach the general purpose foot and align two
holes of button with slot of presser foot.
3. Push the button located on the right side of foot
and lower the foot to hold the button securely.
4. Adjust the stitch width so that the needle enters
the left hole of button.
5. Turn hand wheel by hand so needle enters the
second hole. You may need to adjust the stitch
width again.
CAUTION: To prevent accidents.
Make sure that the needle does not hit the button
during sewing. Otherwise needle may break.
6. Sew approximately 10 stitches at slow speed.
7. Raise the foot and cut the threads remaining
about 10 cm to the fabric.
8. Pull the end of bobbin thread and pull upper
thread to the wrong side of fabric. Tie them
together.
9. After sewing, move the drop feed lever to the
right.
Note:
To sew a 4-hole button, follow the procedure
avobe for the first two holes. Then lift presser foot
slightly and move fabric to permit stitching the
other two holes, either independently, or criss-
cross over the first two holes.
A.Thread Shank
Sew-through buttons on coats and jackets should
have a thread shank to make them stand away
from the fabric. Place a straight pin or sewing
machine needle on top of button between the
holes, and sew over the pin or needle.
Pull thread to back of button and wind around
stitches to form a firm shank. Tie thread ends
securely.
9910EFSt.pm6 2003.9.10, 8:47 PM66
66


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Singer 9910 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Singer 9910 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 1,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Singer 9910

Singer 9910 User Manual - German, Dutch, Italian - 80 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info