616570
8
Zoom out
Zoom in
Previous page
1/47
Next page
5, 6, 8, 10 Stitch Sewing Machine
IMPORTANT SAFETY INSTRUCTIONS
When using this machine, basic safety precautions
should always be followed including the following:
Read all instructions before using this machine.
DANGER - To reduce the risk of electric shock:
* The machine should never be left unattended when
plugged in. Always unplug the machine from the
electric outlet immediately after using and before
cleaning.
* Always unplug before re-lamping. Replace bulb with
the same type rated 15 watts. Be sure to replace the
face plate which covers the light bulb before operating
the machine.
WARNING - To reduce the risk of burns, fire, electric
shock or injury to persons:
* Be sure that the electrical voltage of the socket
outlet (wall receptacle) is the same as the rated
voltage of the motor.
* Use this machine only for its intended use as
described in this Operator's Guide. Use only
attachments recommended by the manufacturer as
contained in the Operator's Guide.
* To disconnect, turn all controls to the off
( "0" )position, then remove plug from outlet.
* Disconnect the power-line plug from the socket
outlet or switch the machine off when making any
adjustments in the needle area, such as threading
needle, changing needle, changing throat plate or
changing presser foot, etc.
* Always unplug the machine from the electrical outlet
when removing covers, lubricating, or when making
any other user servicing adjustments mentioned in the
Operator's Guide.
* Do not attempt to adjust the motor belt. Contact your
nearest Service Center should any adjustment be
required.
* Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
* Handle the foot controller with care and avoid
dropping it on the floor. Be sure not to place anything
on top of it.
* Always use the proper throat plate. The wrong plate
can cause the needle to break.
* Do not use bent needles.
* When sewing, keep fingers away from all moving
parts. Special care is required around the sewing
machine needle.
* Do not pull or push fabric while stitching. It may
deflect the needle causing it to break.
* Before removing the bobbin case, remove plug from
the socket outlet.
* For double insulated machines, when servicing use
only identical replacement parts.
* Never operate the machine if it has a damaged cord
or plug, if it is not working properly, if it has been
dropped or damage, or dropped into the water. Return
the machine to the nearest authorized dealer or
Service Center for examination, repair, electrical, or
mechanical adjustment.
8
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Singer 5828 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Singer 5828 in the language / languages: English as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info