617493
23
Zoom out
Zoom in
Previous page
1/67
Next page
2
1
6
8
7
5
This is a simple operation but it is important to carry out correctly as
by not doing so .
- Start by raising the needle to its highest point (1), and continue
turning the handwheel* counterclockwise until the needle just
slightly begins to descend. You must raise the presser foot to
release the tension discs.
For safety, it is strongly suggested you turn off the power
before threading.
- Lift up the spool pin. Place the spool of thread on the holder with
the thread coming off the spool from the back as shown and
place appropriate spool holder next to the spool. For small
thread spools, place small side of spool holder next to spool. (2)
- Draw thread from spool through the upper thread guide (3) and
pulling thread through pre-tension spring as illustrated. (4)
- Thread tension module by leading thread down right channel. (5)
During this process it is helpful to hold the thread between the
spool and thread guide, as this will help to seat the thread
between the tension discs.
- At the top of this movement pass thread from right to left through
the slotted eye of the take-up lever and then downwards again.
(6)
-
several sewing problems could result
Note:
Now pass the thread behind the horizontal thread guide, and
then behind the thin wire needle clamp guide (7) and then down
to the needle which should be threaded from front to back.
- Pull about 6 - 8 inches of thread under the presser foot to the rear
beyond the needle eye. Trim thread to length with built-in thread
cutter. (8)
* Never turn the handwheel away from you as this may cause the
timing to be disrupted. Always turn the handwheel
counterclockwise (towards you).
3 4
Threading the Upper Thread
EN
16
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Singer 5532 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Singer 5532 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info