634384
20
Zoom out
Zoom in
Previous page
1/30
Next page
18 |
Installation | TP10, TP22 & TP32 User Guide
Interfacing via NMEA
The inbuilt NMEA processor allows NMEA 0183-compatible
equipment to be connected directly to the TP22 and TP32, without
any need for a separate interface unit.
SimNet
GPS/
Chartplotter
Wind Speed
Tillerpilot
power
If a GPS or chartplotter is connected to the Tillerpilot, it can extract
the data necessary for Nav mode. Other functions, such as Steer To
Wind, may also be available if NMEA 0183-compatible instruments
are transmitting the correct NMEA sentences.
When connecting an external (“talker”) unit to the Tillerpilot, two
terminals are used – usually labeled DATA and COMMON (or COM).
These should be connected to the Tillerpilots NMEA cable as
follows:
NMEA talker unit Tillerpilot NMEA
NMEA Out Data/+ Data (Red)
NMEA Out Common/- Common (Blue)
¼ Note: Some third party equipment does not have a dedicated
COMMON connection. In this case, the DATA connection will
usually be labeled NMEA OUT and the NMEA Common wire from
the Tillerpilot should be connected directly to 0V (terminal 2). If in
any doubt, refer to the manufacturer or Simrad’s Product Support
department for advice.
20


Need help? Post your question in this forum.

Forumrules
1

Forum

simrad-tp32

Reset search

  • Simrad TP32 comes up in warning mode, beeping with all lights flasning. How can I get it to Standby mode? (Works fine once in standby/nav mode). Submitted on 26-12-2021 at 23:21

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad TP32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad TP32 in the language / languages: English as an attachment in your email.

The manual is 2,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad TP32

Simrad TP32 User Manual - German - 30 pages

Simrad TP32 User Manual - Danish - 30 pages

Simrad TP32 User Manual - French - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info