634384
13
Zoom out
Zoom in
Previous page
1/30
Next page
| 11
Conguration | TP10, TP22 & TP32 User Guide
- In Calibration mode, press TACK to toggle between Response
Control and Seastate adjustment (indicated by the Port LED
illuminated). The Seastate setting is indicated by the number of
audible beeps and flashes of the Nav LED. The Seastate filter is
“ON” if there is one beep/flash and “OFF” if there are two beeps/
flashes.
- Use the PORT (
) and STARBOARD ( ) keys to switch Seastate
filter ON/OFF.
- Press NAV (CAL) to confirm settings and return to normal
operation.
Autotrim
Under differing conditions a tiller bias (sometimes known as
standing helm or rudder trim) is applied in order to steer a straight
course. An example is when sailing close-hauled, where the vessel
will normally pull into the wind, and the helmsman applies a
standing helm to leeward, in order to maintain course. The amount
of this standing helm varies according to factors such as strength of
wind, boat speed, sail trim, and amount of sail set. If no account of
these were taken, then the vessel would tend to veer off course, or
pull around head-to-wind when sailing close-hauled.
The Tillerpilot continuously
monitors the average course
error and applies a bias to the
tiller to compensate, until the
optimum condition is reached.
This bias, or standing helm, is
applied gradually, so as not to
upset the normal performance
of the Tillerpilot. Thus, it may
take up to a minute or so
to fully compensate after
changing tack. Once optimum
trim is reached, the pilot will
still monitor for changes in
the prevailing conditions and
update the trim accordingly.
Wind
and
Tide
Course
without
Autotrim
Ideal
course
¼ Note: Autotrim is applied automatically and cannot be manually
adjusted.
13


Need help? Post your question in this forum.

Forumrules
1

Forum

simrad-tp32

Reset search

  • Simrad TP32 comes up in warning mode, beeping with all lights flasning. How can I get it to Standby mode? (Works fine once in standby/nav mode). Submitted on 26-12-2021 at 23:21

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad TP32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad TP32 in the language / languages: English as an attachment in your email.

The manual is 2,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Simrad TP32

Simrad TP32 User Manual - German - 30 pages

Simrad TP32 User Manual - Danish - 30 pages

Simrad TP32 User Manual - French - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info