28562
175
Zoom out
Zoom in
Previous page
1/178
Next page
On-board maintenance
165
850-164575 / Rev.D
Lubrication
From the factory, the Hull Unit is lubricated with the types of oil
or grease as specified below. However, if of equal quality, other
types may be used. The numbers below refer to the lubrication
points on the illustration to the left.
(1) The ball bearing on the top of the hoist/lower
screw must be lubricated with normal ball bearing
grease.
(2) The hoisting spindle should be lubricated with
Tonna Slideway Oils S68.
(3) Topping up the shaft sleeve through the grease
nipple is only required if the shaft is dry of
lubrication, or if water tends to force its way up
along the shaft. The shaft sleeve is filled with Esso
Cazar K1.
Warning!
When you top up the shaft sleeve with
oil, you must open the pressure release
plug to avoid damage to the shaft
bearings.
(A) = Pressure release plug
(B) = Air bleeding cock
175


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad SP60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad SP60 in the language / languages: English as an attachment in your email.

The manual is 3,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info